Remanufacturing Instructions
HP LaserJet P 3005
For Technical Support, please call (800) 322-8992 ext 110.
Reference Information:
OEM Part # Yield @ 5%
Q7551A 6500
Q7551X 13000
Fig. 1
1. Pins need to be removed from both ends
of the cartridge to separate the cartridge
halves (Fig. 1).
2. Using a 3/32 inch drill bit, carefully drill
a small hole in the plastic housing where
the cartridge pin is located (Fig. 2).
Fig. 2
© 2007 Oasis Imaging Products, Inc. Page 1
3. Drill into the appropriate area 1/8 inch,
or until the metal pin is exposed (Fig. 3).
Fig. 3
4. Use a small punch or spring hook tool to
push the pin out from the cartridge (Fig 4).
Fig. 4
5. Once the pin is pushed out, you will be
able to use pliers on the pin to fully
remove it (Fig. 5).
Fig. 5
6. Repeat step three to remove the pin from
the opposite end of the cartridge (Fig. 6).
Fig. 6
© 2007 Oasis Imaging Products, Inc. Page 2
7. Repeat steps 4 & 5 to remove the pin
from the cartridge (Fig. 7).
Fig. 7
8. Once the pins are removed, separate the
cartridge halves (Fig. 8).
Fig. 8
9. Gently pry the drum shutter arm from
the side of the cartridge. Be careful not to
lose the tension spring located behind the
arm (Fig. 9).
Fig. 9
10. Remove the silver retaining arms by
gently pulling away from the hopper on
each side of the cartridge (Fig. 10).
Fig. 10
© 2007 Oasis Imaging Products, Inc. Page 3
11. Remove two screws from the end cap
on the geared end of the hopper (Fig. 11).
Fig. 11
12. Remove the end cap (Fig. 12).
Fig. 12
Fig. 13
13. Remove the mag roller drive gear (Fig.
13).
Fig. 14
14. Remove the mag roller stabilizer arm
(Fig. 14).
© 2007 Oasis Imaging Products, Inc. Page 4
15. Remove the mag roller (Fig. 15).
Fig. 15
16. Remove two screws from the mag
contact end cap (Fig. 16).
Fig. 16
Fig. 17
17. Remove the end cap. Remove the
white mag roller stabilizer from the end
cap (Fig. 17).
Fig. 18
18. Clean all the residual grease from the
metal contact on the end cap (Fig. 18).
Replace with a small amount of conductive
grease for reassembly.
© 2007 Oasis Imaging Products, Inc. Page 5
19. Remove two screws that secure the
doctor blade (Fig. 19).
Fig. 19
20. Remove the mag scrapers from each
end of the doctor blade (Fig. 20).
Fig. 20
21. Remove the doctor blade (Fig. 21).
Fig. 21
Fig. 22
22. Clean the toner hopper thoroughly with
compressed air or vacuum. Clean or
replace mag roller and doctor blade, if
necessary. Fill the hopper through the mag
opening with the proper gram load.
Reassemble in reverse order (Fig. 22).
© 2007 Oasis Imaging Products, Inc. Page 6
23. Surrounding the drum axle is the
cartridge sensor tab; using pliers remove
the sensor tab and axle from the drum (Fig.
23). Be careful not to lose the spring
located behind the tab.
Fig. 23
24. Figure 24 shows the correct position of
the spring on the sensor tab for reassembly
(Figure. 24).
If the spring is not installed properly in the
sensor tab, the printer will give an error
message.
Fig. 24
25. Remove the drum (Fig. 25).
Fig. 25
26. Remove the PCR (Fig. 26).
Fig. 26
© 2007 Oasis Imaging Products, Inc. Page 7
27. Remove two screws from the wiper
blade (Fig. 27).
Fig. 27
28. Remove the wiper blade (Fig. 28).
Fig. 28
29. Clean all residual toner from the waste
bin. Clean PCR contact saddle of all
residual grease and apply new. Clean or
replace all components and reassemble in
reverse order (Fig. 29). Connect drum unit
with the toner hopper using the two
cartridge pins.
Fig. 29
30. Remove OEM chip and replace with
aftermarket chip every cycle (Fig. 30).
Fig. 30
© 2007 Oasis Imaging Products, Inc. Page 8
Oasis and You … Succeeding Together!
New Hampshire Tennessee Texas Canada South America
(603) 880-3991 (901) 433-0334 (972) 671-1307 (905) 568-3422 (603) 880-1552
(800) 322-8992 (800) 322-8992 (800) 322-8992 (800) 322-8992 Fax: (305) 383-2558
Fax: (603) 598-4277 Fax: (901) 366-9756 Fax: (972) 671-1359 Fax: (905) 568-3491
Illinois California North Carolina Europe
(630) 982-1543 (714) 283-6270 (919) 776-0847 Netherlands
(800) 322-8992 (800) 322-8992 (800) 322-8992 011-31-24-388-2233
Fax: (630) 928-1542 Fax: (714) 283-6276 Fax: (919) 776-0898 Fax: 011-31-24-355-7373
© 2007 Oasis Imaging Products, Inc. Any attempt to reproduce any part of these instructions without the written consent of
Oasis Imaging Products, Inc. may result in legal action. All registered trademarks are the property of their respective owners.
© 2007 Oasis Imaging Products, Inc. Page 9
