Scribd
Upload
29 views3 pages

The Robotic Joints

Robotic joints are similar to human joints in that they allow for relative motion between two parts of a robot. Each joint provides one degree of freedom and connects an input link to an output link. The basic movements required for most industrial robots are rotational, radial, and vertical. There are two types of joints - translational joints that allow linear or orthogonal motion, and rotary joints that allow rotational, twisting, or revolving motion. Each joint type has a defined range of motion.

Uploaded by

Yossry Awad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
29 views3 pages

The Robotic Joints

Robotic joints are similar to human joints in that they allow for relative motion between two parts of a robot. Each joint provides one degree of freedom and connects an input link to an output link. The basic movements required for most industrial robots are rotational, radial, and vertical. There are two types of joints - translational joints that allow linear or orthogonal motion, and rotary joints that allow rotational, twisting, or revolving motion. Each joint type has a defined range of motion.

Uploaded by

Yossry Awad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

3/11/2020 AUTOMATION

TYPES OF JOINTS

Youssry Awad Taky DR/ Gamal Abd el nasser


The Robotic Joints

 A joint of an industrial robot is similar to a joint in the human body: It provides


relative motion between two parts of the body. Each joint, or axis as it is
sometimes called, provides the robot with a so-called degree-of-freedom (d.o.f.) of
motion. In nearly all cases, only one degree of freedom is associated with a joint.
Robots are often classified according to the total number of degrees-of-freedom
they possess. Connected to each joint are two links, an input link and an output
link. Links are the rigid components of the robot manipulator. The purpose of the
joint is to provide controlled relative movement between the input link and the
output link.

 The basic movements required for the desired motion of most industrial
robots are:
 Rotational movement: this enables the robot to place its arm in any direction
on a horizontal plane.
 Radial movement: this enables the robot to move its end-effector radically to
reach distant points.
 Vertical movement: this enables the robot to take its end-effector to different
heights.
Types of joints

Translational motion
 Linear joint (Type L)
 Orthogonal motion (Type O)

Rotary motion
 Rotational joint (Type R)
 Twisting joint (Type T)
 Revolving joint (Type V)

Each of these joint types has a range over which it can be moved. The range for a
translational joint is usually less than a meter. The three types of rotary joints may
have a range as small as a few degrees or as large as several complete turns.

You might also like