Scribd
Upload
3K views11 pages

BMW Ak90 Key Programmer User Manual

The document provides instructions for installing and using the AK90 software and hardware. It describes: 1) Installing the AK90 software from a CD and selecting "SETUP" to complete the installation. 2) Installing the AK90 driver after software installation and testing the connection by plugging the AK90 into the computer. 3) Various functions of the AK90 software like reading and writing security keys can be used after successfully connecting the AK90 hardware.

Uploaded by

Flávio Marquês
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
3K views11 pages

BMW Ak90 Key Programmer User Manual

The document provides instructions for installing and using the AK90 software and hardware. It describes: 1) Installing the AK90 software from a CD and selecting "SETUP" to complete the installation. 2) Installing the AK90 driver after software installation and testing the connection by plugging the AK90 into the computer. 3) Various functions of the AK90 software like reading and writing security keys can be used after successfully connecting the AK90 hardware.

Uploaded by

Flávio Marquês
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 11

AK90 Operation

Step1 : Install software


Open the AK90 file from CD

Click “ SETUP “ for installing the software

Next step
Next step

Software is installed completely

Next step install driver for AK90

After installing driver plug AK90 to computer to test the connection of AK90 with computer .
PS: The connection port had better is “port2 to port5 “ , you also can change the port
Number in computer manager selection of your computer .
When you plug AK90 to computer if screen shows “ find a new unit “ and then asks you
To install driver for unit , You need to install driver again by manually .

Get into “Disk C” to find out a file called “SiLabs” .

Next step
Next step

Next step

After driver installed completely then plug AK90 to computer .


Note: plug AK90 to PC , you will hear a sound “ Bi “ means unit connects to PC successfully
Then start the software . Do not open the software first without plug AK90 to PC .
If the security key is checked OK , you will hear a sound “ Bi Bi Bi “ for 3 times .
Then you can start every function in AK90 software

Please see the EWS picture on the software for the help with how to
connect MCU for EWS2,3,3+ and EWS4
For EWS2,3 you have to clean the pins on the MCU for reading data .
For EWS4 you only solder a 6 wires on circuit by following the number on the cable.
Reading keys
Writing keys into PCF7935

Waiting for 1 minute , do not move during programming


Or the key will be failed in programming
After programming keys , you also can test the key again to see
If the key number is correct.

Writing keys into EML chips


Please check the battery power if it is in full power before programming

Now you can start the car with the new key , turn ignition on to wait for 5 sec .

Another function
AK90 can read keys with CAS system only , not program .

You might also like