Informational Water Quality Report: Sample Number: 20482
Informational Water Quality Report: Sample Number: 20482
Informational Water Quality Report: Sample Number: 20482
Watercheck w/PO
Client:
This informational water quality report compares the actual test result to national standards as defined in the EPA's Primary and
Secondary Drinking Water Regulations.
Primary Standards: Are expressed as the maximum contaminant level (MCL) which is the highest level of contaminant that
is allowed in drinking water. MCLs are enforceable standards.
Secondary standards: Are non-enforceable guidelines regulating contaminants that may cause cosmetic effects (such as skin
or tooth discoloration) or aesthetic effects (such as taste, odor,or color) in drinking water. Individual
states may choose to adopt them as enforceable standards.
Action levels: Are defined in treatment techniques which are required processes intended to reduce the level of a
contaminant in drinking water.
mg/L (ppm): Unless otherwise indicated, results and standards are expressed as an amount in milligrams per liter or
parts per million.
Minimum Detection The lowest level that the laboratory can detect a contaminant.
Level (MDL):
ND: The contaminant was not detected above the minimum detection level.
The contaminant was not detected in the sample above the minimum detection level.
The contaminant was detected at or above the minimum detection level, but below the standard.
The contaminant was detected above the standard, which is not an EPA enforceable MCL.
Microbiologicals
Total Coliform by P/A Total Coliform bacteria was ABSENT in this sample.
Sodium 4 mg/L -- 1
Physical Factors
We certify that the analyses performed for this report are accurate, and that the laboratory test were conducted by methods approved
by the U.S. Environmental Protection Agency or variations of these EPA methods.
These test results are intended to be used for informational purposes only and may not be used for regulatory compliance.