Scribd
Upload
43 views1 page

Temporary Marking Inverted Spray Paint: Technical Data Sheet

Temporary marking spray paint that is biodegradable and fades after 30-90 days. It is formulated without harmful solvents or pollutants and comes in various colors. The product is intended to mark surfaces like asphalt, concrete, soil and grass. It has a density of 0.66 g/cm3 and evaporates at a rate of 1.0 or greater. Usage instructions include shaking well before and during use, spraying from 6-12 inches away in a steady motion, and using in a well-ventilated area.

Uploaded by

enrique9985
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
43 views1 page

Temporary Marking Inverted Spray Paint: Technical Data Sheet

Temporary marking spray paint that is biodegradable and fades after 30-90 days. It is formulated without harmful solvents or pollutants and comes in various colors. The product is intended to mark surfaces like asphalt, concrete, soil and grass. It has a density of 0.66 g/cm3 and evaporates at a rate of 1.0 or greater. Usage instructions include shaking well before and during use, spraying from 6-12 inches away in a steady motion, and using in a well-ventilated area.

Uploaded by

enrique9985
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Technical Data Sheet

EZ-Paint, Inc., 12209 NW 106 Ct, Suite #106 Medley Fl. 33178 USA 01/06//2011
Tel: +1 (305) 470-0024 www.ez-paint.com

TEMPORARY MARKING INVERTED SPRAY PAINT


Description: Low-impact biodegradable aerosol spray paint formulated to automatically fade away after a period of exposure to the
environment.

Intended Use: Mark asphalt, concrete, gravel, soil and grass.

Product Features: Free of harmful solvents & other pollutants. OSHA and APWA certified colors.
Can be washed off with soap and water. Lasts between 30-90 days.

* Available Colors:

Yellow Pink Orange Red White Blue Green Purple

Physical Properties: Density 0.66 g/cm3 @ 25 °C


Boiling Point -25 °C @ 760 mm Hg
Evaporation Rate ≥ 1.0 (CCl4 = 1.0)
Solubility 7.0% in water
pH 7.5 ± 0.5
Vapor Density 1.6 (air = 1.0)
VOC Content 18.0% (dimethyl ether)

Service Temperature: For best results, use when can is between 70 °F (21 °C) and 90 °F (32 °C)

Surface Preparation: Apply to dry surface.

Directions for Use: Shake can vigorously for at least one minute before and occasionally during use.
Invert can and point spray button towards surface to be marked.
Hold can 6 to 12 inches above surface to be marked.
Press spray button to the side to actuate.
Use steady even stroke while spraying. Use only in well-ventilated areas.

Cold Weather Use: Lower temperatures may affect the performance of this product. Temperature is directly related to pressure. To
increase pressure, warm product to room temperature and apply as instructed.
Do not apply heat directly to the can.
Storage: Keep away from open flames, sources of heat and energized equipment. Do not allow product to freeze. Store at room
temperature. Avoid high temperatures. Keep out of direct sunlight. Keep container in a well-ventilated place. Keep
containers closed when not in use. Keep out of reach of children.

Precautions: CONTENTS UNDER PRESSURE. Concentrated vapors from this product will easily ignite and burn. Dimethyl ether is
heavier than air and may travel a considerable distance to an ignition source. Do not puncture or incinerate (burn)
container. Concentrated vapors may ignite explosively. Keep away from heat, sparks and flame. Do not smoke.
Exposure to heat or prolonged exposure may cause can to rupture violently and cause injury. Do not expose to heat or
flame or store at temperatures above 120ºF. Extinguish all flames and pilot lights, and turn off stoves, heaters, electric
motors and other sources of ignition during use and until all vapors are gone. Prevent concentration of vapors by
opening windows and doors to achieve cross-ventilation.

First Aid: In case of eye contact, flush thoroughly with plenty of water for at least 15 minutes and get medical attention. Avoid
contact with skin or eyes. For skin contact, wash thoroughly with soap and water. If swallowed, do not induce vomiting.
Get medical attention immediately. In case of respiratory difficulties, provide fresh air and get medical attention. Use with
adequate ventilation.

Disposal: Dispose of in a safe matter, in accordance with local, state, federal or provincial waste regulations.

U.S. Patent Nos. 7540907B1, 7220299B2

* colors in print may not match actual applied colors

You might also like