Nomad: Downloaded From Manuals Search Engine

NOMAD
Downloaded from www.Manualslib.com manuals search engine

IMPORTANT SAFETY INSTRUCTIONS 3
UNPACKING 4
GETTING STARTED 5
BLUETOOTH CONNECTION (Bluetooth Devices) 5
CONNECTION USING AUX INPUT 6
CONNECTION MIC/GUITAR 6
FM / USB CHARGING 6
AUTO STANDBY 6
TROUBLESHOOTING 7
SPECIFICATIONS 8
LIMITED WARRANTY 9

- Monster Nomad Speaker
- Power Cable
- User Manual (with Warranty Statement)
- Quick Start Guide
- Mic/Guitar Adapter (6.5mm to 3.5mm)
1
3 4 8
5 6 7
13
9 10 11 12
1 ...... Handle 8 ...... Power On/Off
2 ...... AC connection input 9 ...... Source Select
3 ...... Mic/Guitar Volume Control 10.... Bluetooth Pairing Key
4 ...... LED Interface 11.... Battery Level Indicator
5 ...... Mic/Guitar Port 12.... Radio Preset
6...... USB Port 13.... Volume Knob
7 ...... Aux Input
2

AC the speaker.
AC
- Press the Power switch to "ON" position on top panel of speaker

Power Red LED
The unit will enter into Bluetooth mode,
Bluetooth LED will flash blue.
If the 3.5mm Stereo Audio cable is plugged in during this Power On mode, it will automatically enter into AUX mode.
- By connecting AC power, battery will start charging
- Charge battery about 6 hours in Power off mode

before you start using the unit for the first time
- Battery status by pushing battery button. 100,75,50,25

and battery low on LED display when press battery button.
- The Red Power LED will pulse off and on during battery charging.
- The RED power LED will turn solid when fully charged.
BLUETOOTH CONNECTION (Bluetooth Device)
Place Speaker and your Bluetooth device so they are

no more than 3 feet apart.
Press the Source button until "BT" mode is displayed on LED screen
Press “Bbutton on Speaker to enter
into Bluetooth pairing mode. BT Blue LED will flash .
the
Monster Nomad
- Once selected,your Bluetooth device will indicate

as "Connected" , and you will hear confirmation
tone from the speaker;
- Bluetooth LED turns solid upon completion of pairing. PAIRING USING NFC
- Turn on NFC function on your Bluetooth
enabled device.
- Place your Bluetooth device on the silkscreen

“NFC” on the right side of Monster Nomad handle.
- Confirm Bluetooth connection on your Bluetooth

device. Note: Blue LED indicator will be solid.
- Once paired you can play audio from your Bluetooth

device and audio can be heard from the unit.

Press the Source button until "Aux" mode is displayed on LED screen
Connect Microphone
Connect Microphone
- First plug the supplied "Mic/Guitar" adapter (6.5mm to 3.5mm) to the input
labeled "MIC/Guitar" above the Volume knob
- Once the microphone is plugged in select the "MIC/Guitar" button to Mic position
- Now control your microphone volume on the smaller knob on the far left of the dashboard of the speaker
*Make sure your microphone is also switched to “On”
FM / USB Charging
Listening to FM radio
- Press the "Source" button to select FM source, the radio
station frequency will be displayed on the screen.
- Press and hold (  or ) to search a station with

strongest reception automatically.
Store your favorite four radio stations manually

- Tune to the desired radio station.
- Press and hold a number key (1-4) to enter programming

mode; the corresponding number blinks on the screen;
and the station to save on the selected preset.
- Repeat above steps above to store additional stations.
Select a favorite radio station

- Press the "Source" button to select FM source.
- Press the number 1-4 keys to select one of your favorite

radio stations to listen.
USB Charging (5V/2A)

- With the built in USB power bank, connect your USB
cable to USB power ports. You can
connect an iPhone, iPad, or any Android device.
(USB cable not included)
AUTO STANDBY/ WAKE UP
Auto Standby:
The Power Red LED Signal will turn on and other LED Signals will turn off once the main unit is in Standby mode.
- Bluetooth: When there is no BT Connection, or there is a BT Connection failure, or if the BT has

been disconnected for 15 Minutes, the set will go to standby mode and the BT LED Signal will turn off.
- AUX: The main unit will enter standby mode when the main unit is in Aux mode and no Aux cable has
been detected for 15 minutes.
- Work Mode: When the main unit is in work mode, pressing and holding the volume knob key for
3 seconds will auto enter the unit to Standby Mode.
“Wake up” from standby mode:

If the main unit is in Standby mode, press and hold the volume knob for 1 second. The main unit will turn on
and return to the latest source mode.
6

No power
- Make sure the Guitar is connected through Mic/Guitar converting the header,
and Guitar mode is selected (Press Mic/Guitar button) and Mic/Guitar
volume is turned to a reasonable level;
- Make sure the Mic is connected through Mic/Guitar converting the header, and Mic mode is selected
(Press Mic/Guitar button) and Mic/Guitar volume is turned to a reasonable level;
Audio quality is poor

Speaker.
Cannot pair to Bluetooth device

Speaker
Speaker
Speaker
2

8

Model: Nomad


Nomad: Downloaded From Manuals Search Engine

Uploaded by

Copyright:

Available Formats

Nomad: Downloaded From Manuals Search Engine

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Nomad: Downloaded From Manuals Search Engine

Uploaded by

Copyright:

Available Formats

NOMAD

Downloaded from www.Manualslib.com manuals search engine

BLUETOOTH CONNECTION (Bluetooth Devices) 5

CONNECTION USING AUX INPUT 6

Downloaded from www.Manualslib.com manuals search engine

Downloaded from www.Manualslib.com manuals search engine

- Press the Power switch to "ON" position on top panel of speaker

- By connecting AC power, battery will start charging

- Charge battery about 6 hours in Power off mode

- Battery status by pushing battery button. 100,75,50,25

BLUETOOTH CONNECTION (Bluetooth Device)

Place Speaker and your Bluetooth device so they are

- Once selected,your Bluetooth device will indicate

- Place your Bluetooth device on the silkscreen

- Confirm Bluetooth connection on your Bluetooth

- Once paired you can play audio from your Bluetooth

Downloaded from www.Manualslib.com manuals search engine

- Press and hold (  or ) to search a station with

Store your favorite four radio stations manually

- Press and hold a number key (1-4) to enter programming

- Repeat above steps above to store additional stations.

Select a favorite radio station

- Press the number 1-4 keys to select one of your favorite

USB Charging (5V/2A)

AUTO STANDBY/ WAKE UP

- Bluetooth: When there is no BT Connection, or there is a BT Connection failure, or if the BT has

“Wake up” from standby mode:

Downloaded from www.Manualslib.com manuals search engine

Audio quality is poor

Cannot pair to Bluetooth device

Downloaded from www.Manualslib.com manuals search engine

Downloaded from www.Manualslib.com manuals search engine

Downloaded from www.Manualslib.com manuals search engine

You might also like