PIPE WALL THICKNESS CALCULATION SHEET

PROJECT No. : B710113 DOCUMENT NO. : BIF02-FIP-FEED-RNZ-000-P-CAL-0001

CONDITIONS : 100 % Class Condition 19.980 Kg/cm2 (g) Line Design Condition Kg/cm2 (g)

PIPE SPEC. CLASS 1C605 RATING 150 SERVICE AS PER PIPE CLASS (Note 1)
DESIGN CONDITION PRESSURE (P) 19.980 Kg/cm²(g) TEMPERATURE 35 °C 95 °F
19.600 Bar
OPERATING CONDITION PRESSURE 7.340 Kg/cm²(g) TEMPERATURE 35 °C 95 °F
3 SEAMLESS E 1.00
PIPE MATERIAL
ASTM A106 Gr.B MECHANICAL ALLOWANCE (C1) 0.00 mm
S 20000.00 psi 1406.96 Kg/cm² CORROSION ALLOWANCE (C) 3.00 mm
P * Do
DESIGN THICKNESS t= GOVERNING CODE ASME B 31.3
2( SEW + PY )
tM=t + C + C1 tR =tM / 0.875 Y 0.4 W 1.00

D/T Ratio
PIPE SIZE PIPE SIZE SCHEDULE / delta Delta = T-tR<0, then
Do t tM tR =tM / 0.875 T If D/T <100, then % of tR
D (NB) D (NB) THICKNESS (T-tR) Result = Acceptable
Result = OK
mm Inch mm mm mm mm mm
50 2.00 60.325 0.426 3.426 3.915 5.540 80 OK 161.71% 1.625 Acceptable
80 3.00 88.900 0.628 3.628 4.146 7.620 80 OK 210.05% 3.474 Acceptable
100 4.00 114.300 0.807 3.807 4.351 6.020 40 OK 158.13% 1.669 Acceptable
150 6.00 168.300 1.188 4.188 4.787 7.110 40 OK 169.76% 2.323 Acceptable
200 8.00 219.100 1.547 4.547 5.196 7.040 30 OK 154.83% 1.844 Acceptable
250 10.00 273.100 1.928 4.928 5.632 7.800 30 OK 158.27% 2.168 Acceptable
300 12.00 323.900 2.287 5.287 6.042 8.380 30 OK 158.51% 2.338 Acceptable
350 14.00 355.600 2.511 5.511 6.298 7.920 20 OK 143.72% 1.622 Acceptable

LEGENDS :
S : ALLOWABLE STRESS VALUE. P : INTERNAL DESIGN PRESSURE.
E : WELD JOINT QUALITY FACTOR.
Y : TEMPERATURE COEFFICIENT.
T : SELECTED THICKNESS
DO : OUTSIDE DIAMETER.
t : PRESSURE DESIGN THICKNESS AS PER ASME B 31.3.
tM : MINIMUM REQUIRED THICKNESS INCLUDING CORROSION ALLOWANCE.
tR : THICKNESS INCLUDING MILL TOLERANCE.
W : WELD JOINT STRENGTH REDUCTION FACTOR

NOTES :
1) OLD PIPE CLASS 11003
2) DESIGN PRESSURE (AS PER 100% CLASS CONDITION) = 19.98 Kg/cm2 (g)