Scribd
Upload
50 views1 page

(I) All Questions Are Compulsory. (Ii) There Are Total 16 Questions. Questions 1 To 5 Carry One Mark Each, Questions 6

This document contains a 16 question physics test for class 11 on the topics of vectors, kinematics, forces, oscillations, and dimensional analysis. The test has questions ranging from 1 to 5 marks, testing calculations, definitions, principles, and problem solving abilities. Accuracy and error analysis are assessed on measurement and calculation questions. Key concepts like vector addition, perpendicular vectors, parallel and series resistor combinations, and dimensional analysis formulas are evaluated.

Uploaded by

HOW
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
50 views1 page

(I) All Questions Are Compulsory. (Ii) There Are Total 16 Questions. Questions 1 To 5 Carry One Mark Each, Questions 6

This document contains a 16 question physics test for class 11 on the topics of vectors, kinematics, forces, oscillations, and dimensional analysis. The test has questions ranging from 1 to 5 marks, testing calculations, definitions, principles, and problem solving abilities. Accuracy and error analysis are assessed on measurement and calculation questions. Key concepts like vector addition, perpendicular vectors, parallel and series resistor combinations, and dimensional analysis formulas are evaluated.

Uploaded by

HOW
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Delhi Public School, Greater Noida

Unit Test Date: 24-07-2020


Class XI – Physics
Time 1.5 hours M.M. 35

General Instructions:
(i) All questions are compulsory.
(ii) There are total 16 questions. Questions 1 to 5 carry one mark each, questions 6
to 10 carry two marks each, questions 11 to 24 carry three marks each,
questions 16 carries five marks.

1. Evaluate (⃗⃗⃗ x ⃗⃗⃗ ). ⃗⃗⃗ = ------


2. Write the dimensional formula of (i) resistance (ii) Coefficient of viscosity.
3. Find the value of m in the unit vector 0.5 ̂ – 0.8 ̂ + m ̂ .
4. Write the number of significant figures in the following: (i) 0.0020030 kg
(ii) 020.0340 m.
5. Find the angle between vector ⃗⃗⃗ = 4 ̂ + 4 ̂ - 4 ̂ and ⃗⃗⃗ = 3 ̂ + ̂ + 4 ̂ ?

6. Write four limitations of dimensional analysis.


7. Check the dimensional correctness of the equation T2 = , where T is time, r is
radius, m is mass and G is universal gravitational constant.
8. Two billiard balls are rolling on a flat table. One has velocity component vx = 1m/s,
vy = m/s and the other has component vx = 2m/s, vy = 2m/s. If both balls start
moving from the same point, what is the angle between their paths?
9. Which is easier; pulling or pushing? Why?
10. Find the component of the vector ⃗⃗⃗ = ̂ + ̂ – 4 ̂ along ⃗⃗⃗ = 2 ̂ – ̂ + 3 ̂ .
11. Two resistors of resistances R1 = (100±3) ohm and R2 = (200 ± 4) ohm are connected
in parallel. Find the equivalent resistance of the parallel combination with error limit.
12. The period of oscillation of a simple pendulum is T = 2π . Measured value of L is
20.0 cm known to 1 mm accuracy and time for 100 oscillations of the pendulum is
found to be 90 s using a wrist watch of 1 s resolution. What is the accuracy in the
determination of g?
13. Find a vector of magnitude 18 which is perpendicular to both the vectors:
⃗⃗⃗ = 4î – ĵ + 3 ̂ and ⃗⃗⃗ = –2 î +ĵ– 2 ̂ .
14. The frequency of an oscillating drop may depend upon radius r of the drop, density d
of the liquid and surface tension S of the liquid. Deduce the formula dimensionally.
15. There are two non-collinear unit vectors ̂ and ̂. If |̂ + ̂ | = 3 then find the
value of (̂ + ̂) . (2̂ – ̂)

16. State parallelogram law of vector addition. Write its mathematical form. Also
calculate analytically the magnitude and direction of resultant given by this law.

You might also like