Scribd
Upload
123 views1 page

Firmware Programming Notes For ATRT-01 S3

This document provides steps to update the firmware on the ATRT-01/01B Series 3 device: copy the firmware file to a thumb drive, insert it while holding the STOP key at power on, which will begin the erasure and reprogramming process and restart the device with the new firmware version. Contact Vanguard Instruments for any questions.

Uploaded by

ANGEL ALFONSO NAVARRO LA ROSA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
123 views1 page

Firmware Programming Notes For ATRT-01 S3

This document provides steps to update the firmware on the ATRT-01/01B Series 3 device: copy the firmware file to a thumb drive, insert it while holding the STOP key at power on, which will begin the erasure and reprogramming process and restart the device with the new firmware version. Contact Vanguard Instruments for any questions.

Uploaded by

ANGEL ALFONSO NAVARRO LA ROSA
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Firmware Programming Notes for ATRT-01/01B Series 3

Please use the following steps to program the ATRT-01 S3 firmware.


1. Copy the “ATRT01S3.HEX” file to the thumb drive.
2. Turn off ATRT-01 S3 power.
3. Insert thumb drive into the ATRT-01 S3 USB thumb drive port on the front
panel.
4. Hold “STOP” key on the ATRT-01 S3 key pad and turn on power.
5. When “ERASE” message is shown on the LDC, release “STOP” key.
6. Unit will reprogram itself.
7. Verify new firmware revision when the ATRT-01 S3 restarts itself.

Contact Vanguard Instruments Company at 909-923-9390 or www.vanguard-


instruments.com if you have any questions.

May 27, 2008

You might also like