Scribd
Upload
96 views7 pages

Pe Assignment 1

The document provides specifications for designing a flyback converter including an input voltage of 40V, output voltage of 25V, duty cycle of 0.5, rated load of 62.5W, and switching frequency of 75kHz. It asks to determine: a) the transformer turns ratio, b) the magnetizing inductor value, c) the maximum and minimum inductor current, and d) the capacitor value. It also provides a problem to develop Matlab code for a buck-boost converter design that can perform maximum power point tracking for a PV panel, including designing the converter for two loads: 2W and 100W.

Uploaded by

anum rafiq
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
96 views7 pages

Pe Assignment 1

The document provides specifications for designing a flyback converter including an input voltage of 40V, output voltage of 25V, duty cycle of 0.5, rated load of 62.5W, and switching frequency of 75kHz. It asks to determine: a) the transformer turns ratio, b) the magnetizing inductor value, c) the maximum and minimum inductor current, and d) the capacitor value. It also provides a problem to develop Matlab code for a buck-boost converter design that can perform maximum power point tracking for a PV panel, including designing the converter for two loads: 2W and 100W.

Uploaded by

anum rafiq
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 7

ASSIGNMENT# 1

FLYBACK CONVERTER:
The Flyback converter has these specifications:

DC input voltage: 40V

Output voltage: 25V

Duty cycle: 0.5

Rated load: 62.5W

Max peak-peak inductor current ripple:

25% of the average inductor current.

Maximum peak-peak output voltage: 0.1V

Switching frequency: 75kHz

Based on the abovementioned specifications, determine

a) Transformer turns ratio

b) Value of magnetizing inductor Lm.

c) Maximum and minimum inductor current.

d) Value of capacitor C.

SOLUTION:
BUCK-BOOST CONVERTER:
Develop Matlab Code for design of buck-boost converter that can be used to ensure maximum
power point tracking of the power converter. PV panel I-V characteristics are same as discussed
in buck and boost converters. Design of buck-boost converter must include two loads: a) R= 2W;
b) R=100W.

USING R=100ohms:
Output with R=100ohms:
USING R=2ohms:
Output using 2ohms:

You might also like