Scribd
Upload
15 views2 pages

Design of Purlins (Full Truss) Material Property (NSCP 2010)

The document discusses the design of purlins for a full truss. It provides material properties from the NSCP 2010 and assumes cross section dimensions of 100mm x 150mm. It lists service loads including dead loads from the weight of purlins and roofing and a live load. It provides wind load calculations. The document then provides equations to calculate stresses and deflections based on the loads and material properties.

Uploaded by

Owen Francis Arles Maongat
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
15 views2 pages

Design of Purlins (Full Truss) Material Property (NSCP 2010)

The document discusses the design of purlins for a full truss. It provides material properties from the NSCP 2010 and assumes cross section dimensions of 100mm x 150mm. It lists service loads including dead loads from the weight of purlins and roofing and a live load. It provides wind load calculations. The document then provides equations to calculate stresses and deflections based on the loads and material properties.

Uploaded by

Owen Francis Arles Maongat
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

DESIGN OF PURLINS ( FULL TRUSS)

MATERIAL PROPERTY (NSCP 2010)


Wood
Grade
Fb
Fc
Fc
Fv
Ew
Gw

ASSUME SECTION: 100mm x 150mm

SERVICE LOADS:

Dead Loads
Wt. of Purlins 7.46(0.087)(0.137) = 0.0889 kN/m
Wt of Roofing (GI Sheet No. 20) 0.08(0.76) = 0.06 kN/m
Live Load
Roof slope (33.25%) 1(0.76) = 0.06kN/m
Wind Load
Zone 2: Davao Oriental
V=200Kph
Kz=Kzt=Kd=Iw= 1.0
Load Combination

Dead Load + Live Load

Total Loading

Normal

Tangential
W T length( s)
V=
2
M =W T ¿ ¿
*The breadth (b) is assumed.

6M
F b=
b d2

3V
F v=
2bd

5 W L4
δ=
b d3
384 E( )
12 ¿
¿

l e =l u Single span beam uniformly distributed

le d
C s=
√ b
C k =0.811 √ E/ F b
2

*If Cs < 10,


F b' =Fb
*If 10 < Cs < Ck

F b' =Fb ¿ ¿
*If Ck < Cs < 50
0.438 E
F b' =
C s2

You might also like