Knots and String
Knots and String
Knots and String
Troop 24
Kennett square
pennsylvania
36
Shoe Lacings
Table of Contents
2 35
Signal Tower Eye Splice..................................................................................................... 28
Back Splice................................................................................................... 29
Short Splice .................................................................................................. 30
Ten Minute Tower........................................................................................ 31
Brynbach Tower ........................................................................................... 32
Bridges ......................................................................................................... 33
Signal Tower ................................................................................................ 34
Shoe Lacings ................................................................................................ 35
The ‘IAN’ Shoelace Knot............................................................................. 35
Escher Towers .............................................................................................. 35
About This Booklet ...................................................................................... 36
Baden-Powell,
founder of
scouting
movement
oversees a
pioneering project
34 3
Pioneering Merit Badge Requirements Bridges
1. Show that you know first aid for injuries or illness that could
occur while working on pioneering projects, including minor
cuts and abrasions, bruises, rope burns, blisters, splinters,
sprains, heat and cold reactions, dehydration, and insect
bites or stings.
2. Do the following:
a. Successfully complete Tenderfoot requirements 4a and 4b
and First Class requirements 7a, 7b, and 7c. (These are
the rope-related requirements.)
b. Tie the following: square knot, bowline, sheepshank,
sheet bend, and roundturn with two half hitches.
c. Demonstrate the following: tripod and round lashings.
3. Explain why it is useful to be able to throw a rope, then
demonstrate how to coil and throw a 40-foot length of 1/4-
or 3/8-inch rope. Explain how to improve your throwing
distance by adding weight to the end of your rope.
4. Explain the differences between synthetic ropes and Monkey Bridge
natural-fiber ropes. Discuss which types of rope are suitable
for pioneering work and why. Include the following in your
discussion: breaking strength, safe working loads, and the
care and storage of rope.
5. Explain the uses for the back splice, eye splice, and short
splice. Using 1/4- or 3/8-inch three-stranded rope,
demonstrate how to form each splice.
6. Using a rope-making device or machine, make a rope at
least 6 feet long consisting of three strands, each having
three yarns.
7. Build a scale model of a signal tower or a monkey bridge.
Correctly anchor the model using either the 1-1-1 anchoring
system or the log and stake anchoring method. Describe the
design of your project and explain how the anchoring system
works.
8. Demonstrate the use of rope tackle to lift a weight of 25 Suspension Bridge
pounds and pulling a log at least 6 inches in diameter and 6
feet long with the tackle. Use the tackle to put tension on a
line. Explain the advantages and limitations of using a rope
tackle. In your explanation, describe the potential damage
that friction can do to a rope.
9. By yourself, build an A-trestle OR X-trestle OR H-trestle
using square and diagonal lashings. Explain the application
of the trestle you build. Demonstrate how to tie two spars
together using a shear lashing.
10. With a group of Scouts, OR on your own, select a pioneering
project. With your counselor's guidance, create a rough
sketch of the project. Make a list of the ropes and spars
needed, then build the project. (Note: This requirement
may be done at summer camp, at district or council events,
or on a troop camp outing.) Double Lock Bridge
4 33
Brynbach Tower Pioneering Knot List
Knot or Lashing Rank/ Handbook Page Notes
Square Knot Scout Rank P. 8
Clove Hitch 1st Class 7B – P. 139
Timber Hitch 1st Class 7B – P. 138
Bowline 1st Class 8A – P. 149
MB
Hitches
Whip & Fuse Rope Tenderfoot Rank 4A – P. 34
Two Half Hitches Tenderfoot Rank 4B – P. 36
Taut-Line Hitch Tenderfoot Rank 4B – P. 36
Square Lashing 1st Class 8A – P. 141
Shear Lashing 1st Class 8A – P. 142
Diagonal Lashing 1st Class 8A – P. 143
Pioneering MB Additional Knots
Double Sheet Bend Honda
Carrick Bend Prussic
Rolling Hitch Cat’s Paw
Pipe Hitch Rope Tackle
Barrel Hitch Fisherman’s Knot
Constrictor WC Shear Lashing
Bowline on a Bight Butterfly Knot
Water Knot Masthead Knot
32 5
Ten Minute Tower
Rope Care and Safety
SELECT BEST ROPE FOR THE JOB. Choose the right material,
size and strength.
STORE ROPE PROPERLY. Rope should be dry, untied, properly
coiled after use.
KEEP ROPE CLEAN. Dragging rope on the ground or floor causes
abrasive dirt to weaken the rope fibers.
KINKS CAUSE ROPE FAILURE. Kinks cause damage. Straighten
them by twisting, not pulling.
AVOID SUDDEN STRAINS. Jerks may break a rope normally
strong enough to handle the load safety. A steady, even pull assures
full strength from rope.
DOUBLE CHECK all poles, ropes, knots, lashings, anchors etc.
before using any pioneering structure.
6 31
Short Splice Rope Materials, Characteristics and Use
Laid Rope
Laid rope is made up of fibers twisted into yarns that are twisted
into strands and laid into a rope.
Braided Or Woven Rope
Twelve-Strand Braided Ropes: 12 strands are
(I) Unlay the lay of both ropes for several times the rope braided over and under each other in a maypole
diameter. A temporary whipping one will prevent unraveling. fashion to create a hollow, tubular structure.
Marry the strands together alternating one from each end.
Plaited Ropes: Eight strand plaited rope formed by
(II) Tuck F under E and G under D intertwining four pairs of strands in a maypole
fashion with two pairs moving clockwise and two
(III) First two tucks completed pairs moving counter-clockwise.
(IV) Rotate the splice 180 degrees and tuck H under C. This Double Braided Ropes: Two ropes in one, a
completes the first set of tucks. braided core is over-braided with a cover braid,
hence the terms braid on braid and 2 in 1 braid.
Continue tucking F,G and H
over one lay and under the next.
Remove the temporary whipping Hollow & Diamond Braids: A hollow, tubular
and tuck C, D and E over one structure braided in a maypole fashion to produce a
strand and under the next . Tuck plain braid pattern with and without a core
each lay three times
Solid Braids: The strands are intertwined by
braiding in a circular pattern to form a solid tubular
structure.
30 7
Pioneering Uses Back Splice
Natural
Fibers
Cost
Stretch
Sunlight Resistance
Rot Resistance
Workability
Strength
Durability
Knotting
Lashing
Tackle
Anchor -
Footrope
Manila $$ + G G E G G X X X X
2-3 Form crown knot as
Sisal $ ++ G P G F F X X shown. From above it should
Cotton $ G P G F G look like this:
Synthetic Fibers
Polypropylene $$ + P E F G G X
Polyethylene $ + F E
Polyester $$$ - E E G E X X X X
Nylon $$$ ++ G E E E E X X X
Manila Perhaps the best overall rope. It has a good size to strength
ratio, does not stretch too much and handles well when tying knots
and lashings. While it can withstand frequent wetting and drying it
must be stored dry to avoid mildew and rot. 4. Tuck one lay over the
Sisal Has a poor size to strength ratio, does not handle well and wears adjoining end and under itself.
our quickly. While it is less expensive than manila it’s limited use and
durability make it a second choice for pioneering.
Cotton Braided or twisted cotton is outclassed in strength and
durability by just about all other ropes. It is suitable for clotheslines
and hammocks but not for pioneering or camping. 5. Tuck the next strand over
Polypropylene Has an excellent strength to size ratio, handles well and under
but weakens with long exposure to sunlight.
Nylon The stretch factor in nylon rope makes it difficult to work with
when lashing. An excellent size to strength ratio and durability make 6 Tuck the remaining strand
it a good rope for general use. over and under.
Polyester Most braided climbing ropes are polyester. It handles well,
has an excellent weight to strength ratio and limited stretch factor. It To finish the back splice
is much more expensive than manila or nylon ropes and has limited continue tucking each lay over
use in pioneering. and under several times.
Polyethylene The least expensive of the synthetic fiber ropes. It’s
stiffness and poor handling qualities make it undesirable for
pioneering. The
Binder Twine Loosely twisted jute fibers treated with oil. It serves as finished
a lightweight cord for throw-away uses such as lashing small splice
diameter poles or staves for camp gadgets. Binder twine is used to
demonstrate rope making and can serve as a reasonably good fire
starter
8 29
Eye Splice Sail Maker’s Whipping
(1)&(2) Count back and unlay 5
rounds of the lay of the rope. 1. Begin by unlaying
3) Fan the unlaid end of the rope and
place it over the standing part of the
(untwisting) the rope two
rope. The strand to the inside of the inches. Make a bite in a 3-
eye must look like it is coming out foot length of whipping
from under the other two strands and thread and place it around
the other two strands must be fanned one of the strands.
in such a way that they do not cross
each other.
2. Re-lay the rope. Wind the
(4) While holding the inside strand whipping thread tightly
in place, stick the middle strand around the rope end for a
under one of the strands of the sufficient number of turns.
standing end of the rope.
3. Carry the bight originally
(5) Pass the inside strand over the
standing end strand and stick it formed back over the end of
under the next standing end strand. the same strand around which
N0TE: The second strand goes in it was laid.
where the first strand came out. (6) 4.Pull ends tight and tie them
Turn the splice over.
with a square knot between
(7) Stick the third strand under the
remaining strand of the standing end. the rope ends. Trim ends of
NOTE: The third strand is stuck in whipping thread.
where the second strand came out
and comes out where the first strand English Whipping
went in. [NOTE] When the third
strand is stuck it appears to go
backward but when it is examined Form a loop in
closely you will see that it is stuck in whipping thread and
the same direction as the other two lay it along the end.
strands. Wrap the whipping
(8B) & (8F) Complete the splice by thread tightly around
working the strands snug and adding the rope. When the
3 to 5 50unds of tucks. NOTE: whipping is as wide as
When the strands are folded back the rope is thick, slip
over the eye, you will notice that the end through the
there is one strand going in and one
loop, pull hard, and
strand coming out between each of
the strands of the standing end trim whipping thread.
28 9
Knot Tying Terms Turks Head Neckerchief
Slide
10 27
Monkey’s Fist Knots
Bends
Grommet
The first and almost always best way to join the ends of two ropes.
26 11
Fisherman’s Knot
Pioneering Anchors
Sheepshank
12 25
Trestle Hitches
Rolling Hitch
If you look at this hitch closely you see that it is really a clove hitch
that ends with a turn. Best tied so that the load pulls against the hitch
as shown.
Pipe Hitch
Celtic Knotwork
24 13
Filipino Diagonal Lashing
Round Turn & Two Half Hitches
Scaffold Hitch
14 23
Japanese Square Lashing Barrel Hitch
Provides a lifting sling for barrels or buckets. Two hitches will help
stabilize the load.
Constrictor
22 15
Loop Knots Lashings
Jug Knot
Gin Tripod Lashing
16 21
Rope Tackle
Bowline on a Bight
Forms two fixed loops and can be tied without access to the ends of
the rope
Butterfly Knot
20 17
Masthead Knot Prussic Knot
Cat’s Paw
Honda Knot
Placed on the top of a pole or mast this knot forms loops for guy lines
Forms a running loop or lasso.
to support the pole.
18 19