Scribd
Upload
127 views2 pages

SW200B Cal

The document provides installation and calibration instructions for the SW-200B Speed Switch. It details how to mount the switch, wire it, set the DIP switches, calibrate the setpoints using a signal generator, and adjust the trim pots. A connection diagram and specifications are also included.

Uploaded by

joseluise68
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
127 views2 pages

SW200B Cal

The document provides installation and calibration instructions for the SW-200B Speed Switch. It details how to mount the switch, wire it, set the DIP switches, calibrate the setpoints using a signal generator, and adjust the trim pots. A connection diagram and specifications are also included.

Uploaded by

joseluise68
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Installation and Calibration Instructions

SW-200B Speed Switch


1. Installation: Mount the SW-200B to a secure bracket off the engine. If
on-engine mounting is necessary, shock mounts are recommended. Wire
according to connection diagram on reverse. Shielded cable is
recommended. Shield should be brought to ground directly. The SW-200B
will work with most magnetic pickups provided the signal amplitude is
greater than 50 mVrms and less than 70 Vrms. Mount pickup according
to manufacturer’s instructions.
2. Calibration: Determine the setpoint frequencies from an RPM value
using the following formula:
RPM x No. of Teeth (Holes)
Frequency =
60
A. Verify the current calibration: use a signal generator. Connect it to the
SW-200B magnetic pickup input.
B. Confirm the DIP switches are properly set for the frequency range and
overspeed relay logic desired. (See chart below.)
C. Set the signal generator output to at least 10% below the lowest setpoint.
Slowly increase the frequency. Using an ohmmeter across the relay
contacts, determine the frequency at which each relay changes state.
a. Change a setpoint: remove the appropriate access hole screw to reach
the setpoint's relay adjustment trim pot.
b. Set the signal generator to the frequency at which the relay should change
state. Connect it to the SW-200B magnetic pickup input.
c. Using a small, flat screwdriver, adjust the trim pot for the appropriate
relay until the relay changes state.
d. Decrease the frequency, then slowly increase it to verify that the relay
trips at the appropriate point. Replace the access hole screw.

DIP SWITCH SETTINGS


Switches 1 & 2 set the Switches 3 & 4 set the
full-scale frequency range overspeed relay logic
DIP DIP Full-Scale DIP DIP Relay
SW 1 SW 2 Range SW 3 SW 4 Logic
Energizes
OFF OFF = 0 – 11,200 Hz ON N/A = Above
Setpoint
De-Energize
OFF ON = 0 – 5,000 Hz OFF N/A = Above
Setpoint
ON ON = 0 – 1,000 Hz N/A ON = Latches
Does not
N/A OFF =
Latch

SW-200B is a trademark of Dynalco Controls


DYNALCO CONTROLS RESERVES THE RIGHT TO CHANGE THESE SPECIFICATIONS WITHOUT NOTICE.

Azonix-Dynalco, 3690 N.W. 53rd Street, For t Lauderdale, FL 33309 U.S.A.


( 954 ) 739- 4300 • Fax (954 ) 484-3376 • ww w.dynalco.com • [email protected]
© 2002 Azonix-Dynalco 145F-12044, Rev 0
CONNECTION DRAWINGS
SW-200B

You might also like