Stitching Cards: Maltese Cross

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

Stitching Cards

Maltese Cross
These pattern details should be used in conjunction with the Stitching Cards General Instructions.
“Out at …” means passing the needle through a hole from the back of the card to the front.
“In at …” means passing the needle through a hole from the front of the card to the back.

Stitch the design in colours of your choice.

Circle outline AD Cross section 1


E

Cross section 1.
Out at A in at B.
Out at C in at D.
Out at E in at F.
Continue this sequence until section 1
is complete using the illustration as a
guide.
Stitch section 2 in a similar way using Cross
section 2
the illustration as a guide.
Circle outline.
Work the circle outline in stem stitch.

FC
B

Copyright © 2015 Stitching Cards

Published at www.stitchingcards.com E-mail [email protected]


This Maltese cross Stitching Cards pattern can be used to produce cards for personal pleasure and personal giving.
Any card made from this pattern and offered for sale must include an official copyright sticker. Copyright stickers can be
purchased from www.stitchingcards.com.
Reproduction of this Maltese cross pattern is allowed for personal or teaching use. This copyright notice should appear on
all copies of the pattern.
This pattern is exclusively available from www.stitchingcards.com.
This free sample pattern was published by Stitching Cards. If you would like to be informed when new Stitching Cards
designs are ready for sale at www.stitchingcards.com then please visit our web site and join our mailing list.
Maltese Cross

152 mm

Copyright © 2015 Stitching Cards

104 mm

When printing the pricking pattern please set your printer scaling to "Actual size" if available. If there is a "Fit to page"
setting on your printer settings then make sure this is not selected.
The page is based on an A4 sheet (210 x 297 mm) but should print on slightly different sized sheets correctly if the scaling
is set as suggested above.
The pattern size of 104 x 152 mm (4½ x 6 inches) is given as a guide and may vary slightly on your printer. If it varies
then centre the pattern on your card as necessary.

Published at www.stitchingcards.com E-mail [email protected]


This Maltese cross Stitching Cards pattern can be used to produce cards for personal pleasure and personal giving.
Any card made from this pattern and offered for sale must include an official copyright sticker. Copyright stickers can be
purchased from www.stitchingcards.com.
Reproduction of this Maltese cross pattern is allowed for personal or teaching use. This copyright notice should appear on
all copies of the pattern.
This pattern is exclusively available from www.stitchingcards.com.
This free sample pattern was published by Stitching Cards. If you would like to be informed when new Stitching Cards
designs are ready for sale at www.stitchingcards.com then please visit our web site and join our mailing list.
Stitching Cards General Instructions
Published at www.stitchingcards.com

You will need a suitable pricking mat. This could be foam or felt but should allow easy penetration of
the pricking pin whilst protecting your work surface. Lay your blank card onto the pricking mat with the
right side (outside) of the card facing upwards.
Place the pricking pattern on the card in the required position. Use a fine pricking tool to pierce through
the pattern and the card. If you do not have a purpose made pricking tool then a hat pin or similar can
be used.
Remove the pricking pattern. The pricked holes can be seen on the card.
Turn the card over so the wrong side (inside) is uppermost.. Select a suitable thread such as Kreinik
metallic cord. Use a Number 10 embroidery needle. Use a length of thread that you are comfortable
with. We suggest using about a third of a metre (14 inches). Secure the end of the thread to the card
with adhesive tape. Pass the needle through the start hole from the back to the front of the card.
Follow the instruction diagram. Refer to the finished diagram from time to time to see the complete
stitching required.
When the thread on your needle runs out secure the end of the thread with adhesive tape on the back
of the card and start a new thread.
Continue to follow the instructions a section at a time. Some patterns uses beads. These are held in
place with stitching. You may need to use a beading needle if the bead holes are very fine.
If you are using a double fold card (a card with three panels) then place the completed card on your
work surface with the right side facing downwards. Fold the left-hand panel across to cover and hide
the back of the stitching work. Secure the panel in place with double-sided adhesive tape or card
adhesive. The stitching of your card is now complete. You may choose to add a suitable greeting with
stickers, stamping or handwriting.
Stitching Terminology.
Where the instructions say “Out at” this means passing the needle through a hole from the back of the
card to the front.
Where the instructions say “In at” this means passing the needle through a hole from the front of the
card to the back.

Where the design calls for back stitch this works as follows:
Out at 2 in at 1
Out at 3 in at 2 1 2 3 4
Out at 4 in at 3

Where the design calls for stem stitch this works as follows:
Out at 1 in at 3
Out at 2 in at 4 1 2 3 4 5
Out at 3 in at 5

Copyright © 2015 Stitching Cards


Web site www.stitchingcards.com
Stitching Cards, PO Box 795, St. Albans, AL2 2ZQ, UK

You might also like