Scribd
Upload
44 views

For The Systems Shown Below Draw The Block Diagram Using SIMULINK See The Output in The Scope With Respect To Input

The document provides instructions for modeling and simulating two systems in Simulink. The first system is an RLC circuit with a unit step input where the output response i(t) is observed. The second system is a mass-spring-damper system with a step input where the output response x(t) is observed. It also provides a third order differential equation system and instructs to draw the Simulink model and plot the output response y(t) with respect to the input u(t).

Uploaded by

Acharya Suyog
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
44 views

For The Systems Shown Below Draw The Block Diagram Using SIMULINK See The Output in The Scope With Respect To Input

The document provides instructions for modeling and simulating two systems in Simulink. The first system is an RLC circuit with a unit step input where the output response i(t) is observed. The second system is a mass-spring-damper system with a step input where the output response x(t) is observed. It also provides a third order differential equation system and instructs to draw the Simulink model and plot the output response y(t) with respect to the input u(t).

Uploaded by

Acharya Suyog
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

1.

For the systems shown below draw the block diagram using SIMULINK see the output in
the scope with respect to input

Consider u(t) a unit step input and i(t) the


output; assume L = 0.01 and R = 0.01 and
zero initial conditions.

`
Consider F(t) a step input and x(t) the output;
assume m = 2Kg, K= 32 and B = 2N-s/m and
zero initial conditions.
2. For the system defined by the equation
3
d y d2 y dy
2 3 + 4 2 +8 +10 y=10 u ( t )
dt dt dt
Draw the SIMULINK block diagram and plot the output response y (t) with respect to
u (t).

You might also like