Scribd
Upload
34 views

Latexexample PDF

This document contains a snippet of Arduino code that writes log data to an SD card. It uses the SD library to begin accessing the SD card using pin 10, then creates and opens a new CSV file on the card to write log data to. The code loops through file names until it finds one that does not already exist, and writes "Hello" to that file every second.

Uploaded by

cristian
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views

Latexexample PDF

This document contains a snippet of Arduino code that writes log data to an SD card. It uses the SD library to begin accessing the SD card using pin 10, then creates and opens a new CSV file on the card to write log data to. The code loops through file names until it finds one that does not already exist, and writes "Hello" to that file every second.

Uploaded by

cristian
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

1 SD Card Example

Below is a snippet of arduino code. It was added via the input of the external
file arduinoLanguage.tex. A custom style was then created at the top of this
file so that the non-built-in functions and classes like SD and open() would
highlight properly. The style also adds the pretty box around the code. To
see how this was accomplished, check out latexExample.tex.

1 #include <SD.h>
2
3 File logfile;
4 byte logPin = 10;
5
6 void setup() {
7 SD.begin(logPin);
8
9 ///////// Create a new file //////////
10 char filename[] = "LOGGER00.CSV";
11 for (int i = 0; i < 100; i++) {
12 filename[6] = i/10 + ’0’; // number the file
13 filename[7] = i%10 + ’0’; //
14 if ( SD.exists(filename)==false ) { // only open a
new file if it doesn’t exist
15 logfile = SD.open(filename, FILE_WRITE);
16 break; // leave the loop!
17 }
18 }
19 }
20
21 void loop() {
22 // put your main code here, to run repeatedly:
23 logfile.println("Hello");
24 logfile.flush();
25 delay(1000);
26 }

You might also like