Scribd
Upload
588 views

Coding Guide Adding $6FL

This document provides steps for adding option 6FL to a BMW vehicle and making associated coding changes. The steps include opening INPA and NCSEXPERT software, selecting the correct vehicle and options, and executing write and coding jobs to update the CAS, NFRM, CIC, and MEDIA control units. Once all steps are completed, the option 6FL will be fully added and coded to the vehicle.

Uploaded by

dradubuh002
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
588 views

Coding Guide Adding $6FL

This document provides steps for adding option 6FL to a BMW vehicle and making associated coding changes. The steps include opening INPA and NCSEXPERT software, selecting the correct vehicle and options, and executing write and coding jobs to update the CAS, NFRM, CIC, and MEDIA control units. Once all steps are completed, the option 6FL will be fully added and coded to the vehicle.

Uploaded by

dradubuh002
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Coding guide: Adding Option 6FL

Step One – Adding $6FL

Open INPA and verify that it is connected properly.

 Close INPA when verified.

Open NCSEXPERT and load profile:  Expertenmodus.


Press VIN/ZCS/FA (F1)
Press ZCS/FA f. ECU (F3)

 Choose the E89 chassis

 Choose CAS or NFRM


Press Enter FA (F2)

 Choose E89
Enter VIN: WBAUY110X0A871316

 OK
Add $6FL

 OK
Press Back (F6)
Press Process ECU (F4)

 Choose CAS
Press Change Job (F2)

 Choose FA_WRITE

 OK
Press Execute job (F3)
Press Change ECU (F1) –> Choose NFRM
Press Execute job (F3)
Step Two – Code changes to CIC

Open INPA and verify that it is connected properly.

 Close INPA when verified.

Open NCSEXPERT and load profile:  Expertenmodus

Press VIN/ZCS/FA (F1)


Press ZCS/FA f. ECU (F3)

 Choose the E89 chassis

 Choose CAS or NFRM


Press Back (F6)
Press Process ECU (F4)

 Choose CIC
Press Change Job (F2)

 Choose SG_CODIEREN
Press Execute job (F3)
Press Process ECU (F4)

 Choose MEDIA
Press Execute job (F3)

Done

You might also like