Scribd
Upload
16 views1 page

Course: Tutorial: CEB706 - Designed of Reinforced & Pre-Cast Concrete Structures 03 - Module 3

This document contains a tutorial for a reinforced concrete structures design course. It includes 3 questions about calculating properties of reinforced concrete beam sections, such as required steel area, design moment capacity, and neutral axis depth. Question 1 asks to calculate these values when the neutral axis is at its limiting depth. Question 2 asks to calculate the minimum effective depth of a beam section if the steel ratio is 1% of the concrete area. Question 3 asks to calculate the neutral axis depth and design moment capacity for a beam section with varying steel areas.

Uploaded by

Shavin Chand
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
16 views1 page

Course: Tutorial: CEB706 - Designed of Reinforced & Pre-Cast Concrete Structures 03 - Module 3

This document contains a tutorial for a reinforced concrete structures design course. It includes 3 questions about calculating properties of reinforced concrete beam sections, such as required steel area, design moment capacity, and neutral axis depth. Question 1 asks to calculate these values when the neutral axis is at its limiting depth. Question 2 asks to calculate the minimum effective depth of a beam section if the steel ratio is 1% of the concrete area. Question 3 asks to calculate the neutral axis depth and design moment capacity for a beam section with varying steel areas.

Uploaded by

Shavin Chand
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Tutorial 3 Week 3

Course: CEB706 – Designed of Reinforced & Pre-Cast Concrete Structures


Tutorial: 03 – Module 3
3
Assume the specific weight of the reinforced concrete as 24 kN/m

Q1:
A rectangular beam section has b=350 mm, d=540 mm and f’c=40 MPa. Calculate the
required steel area when the neutral axis is at its limiting depth. Calculate the steel area (Ast)
*
and the design moment capacity (M ) of the section.
Q2:
A simply supported beam has a span of 7200 mm, a dead load of 20 kN/m and a live load of
18 kN/m. The width of the beam is 300 mm and f’c=32 MPa. If the steel area is 1% of the
effective area of the concrete, what is the minimum effective depth of the section?

Q3:
A rectangular beam section has b=300 mm, d=450 mm. The beam has constructed using
Grade 32 concrete (f’c=32 MPa). Calculate the neutral axis depth (x) and the design moment
*
capacity (M ) of the section for following cases?
2
i. Ast=1350 mm
2
ii. Ast=3000 mm
2
iii. Ast=4370 mm

You might also like