Scribd
Upload
114 views1 page

Bct-Feature and Block Diagram

The document describes a battery charger and capacity tester that has the following key components: 1. An SMPS that converts 220V AC input to DC output for charging and discharging batteries. 2. A microcontroller board based on ATMEGA that controls charging, discharging, monitors battery voltage and polarity, and stores data. 3. Real-time current monitoring during charging from 1A to 8A and discharging from 1A to 15A to calculate battery capacity.

Uploaded by

Akshay Sharma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
114 views1 page

Bct-Feature and Block Diagram

The document describes a battery charger and capacity tester that has the following key components: 1. An SMPS that converts 220V AC input to DC output for charging and discharging batteries. 2. A microcontroller board based on ATMEGA that controls charging, discharging, monitors battery voltage and polarity, and stores data. 3. Real-time current monitoring during charging from 1A to 8A and discharging from 1A to 15A to calculate battery capacity.

Uploaded by

Akshay Sharma
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Battery Charger & Capacity Tester

Block Diagram Of Battery Charger & Capacity Tester

SMPS -
DC
220 V Input 220V AC Charging Control
Fuse Out Real Time
Current Monitor
+
Discharging Control
Current Monitor
& Isolation Polarity Protection +
Battery
Voltage Battery
Load & Terminals
Polarity -
Detection

Over Charging Discharging Real Time Charging Battery Battery


Isolation Polarity
Current PWM PWM & Discharging Voltage Polarity
Signal Signal
Fault Signal Signal Current Monitoring Monitor Monitor
Signal
Input From Keyboard Keys Non Volatile Memory for Power
Failure

ATMEGA Based Microcontroller Controller Board

Features:-
 In Put Voltage 220V AC
 Unit for Set of Four Batteries ( Battery Voltage Range 10.5 (Discharge) to 14.5 (Charge )Volts)

Charging :-
 Real Time Charging Control from 1A to 8A in 8 Steps. (Accuracy As Per Your Recommendation)

Discharging:-
 Real Time Discharging Control from 1A to 15A in 15 Steps & Real Time Capacity Calculation.
(Accuracy As Per Your Recommendation)

 Data Protection at Power Failure & resume at power at same function as on Power Failure
 Fully microcontroller based design
 SMPS based Design

You might also like