Scribd
Upload
200 views2 pages

ReleaseNote OmniPC 4.4R5

This document contains release notes for multiple versions of OmniPC software. The 4.4R5 version added Polish language support and fixed issues. The 4.4R4 version added compatibility with Veriphase ADT software. The 4.4R3 version contained improvements to the acquisition software but no changes to OmniPC.

Uploaded by

phanthanhhung
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
200 views2 pages

ReleaseNote OmniPC 4.4R5

This document contains release notes for multiple versions of OmniPC software. The 4.4R5 version added Polish language support and fixed issues. The 4.4R4 version added compatibility with Veriphase ADT software. The 4.4R3 version contained improvements to the acquisition software but no changes to OmniPC.

Uploaded by

phanthanhhung
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

OmniPC 4.

4 Release Notes
OmniPC 4.4R5 2019-05-24

New features
- Addition of Polish version.

Resolved issues from the previous version


- Fixed indication reference numbers and “X” positions.
- Fixed Italian version installer.

OmniPC 4.4R4 2018-03-23

New features
- Added compatibility with Veriphase ADT (Automatic Detection Technology) software.

OmniPC 4.4R3 2017-05-31

Improvements from the MXU 4.4R3 software are limited to the acquisition software running on the OmniScan MX2 and
SX. No impact on the OmniPC software.

OmniPC 4.4R2 2017-03-03

New features

• DGS PA & UT sizing technique major updates


o Updated DGS sizing wizard.
o Addition of DGS curves on all focal laws.
• Addition of TomoView compatibility for MXU 4.4 files

Resolved issues from the previous version

• Customer reported and other minor stability issues have been fixed.
o TminZ reading source refresh issue has been fixed.
o Thickness changing causing calibration clear has been corrected.

OmniPC 4.4R1 2016-28-11


New features
- Long seam weld inspection (Axial scan with COD wedge)
o Updated Part & Weld Wizard.
o R-Scan with corrected volumetric position of indications in the gate.
- A-C-R-S layout
- A-B-S Layout
- New Readings
o S(m-r)CSC: represents the scan length corrected for part curvature and flaw depth.
o TOF Readings (TOF:U(r), TOF:U(m), TOF:U(m-r)): represents the position of ultrasonic cursors in the part
in microseconds
o Aspect ratio readings (h/l Ratio, h/t Ratio): calculations of the defect height to the length of the
indication or the defect height to the part thickness.

You might also like