Security Systems

From Our Reference Tel Fax Grasbrunn

Markus Ibba +498962901460 11.04.2013

Report

Issue Release 1.1

Topic FPA-5000 USB Driver Installation for Windows 7 and Windows
8
Description This document describes the installation of the USB driver for FPA-
5000 for Windows 7 / 8 (32-Bit and 64-Bit).

1 Introduction ......................................................................................................................... 2
2 Driver Installation ................................................................................................................ 2
2.1 Prerequisites ............................................................................................................... 2
2.2 First Steps ................................................................................................................... 2
2.3 Identifying the FPA-5000 device .................................................................................. 3
2.4 Installing the driver ...................................................................................................... 4

Picture 1 - Installing Device Driver ............................................................................................. 2

Picture 2 - Driver Installation failed ............................................................................................ 2
Picture 3 - Driver installation failure dialog ................................................................................. 3
Picture 4 - Device Manager ....................................................................................................... 3
Picture 5 - Device Properties ..................................................................................................... 4
Picture 6 - Update Driver Software ............................................................................................ 5
Picture 7 - Install Driver for unknown device .............................................................................. 5
Picture 8 - Browse for driver ...................................................................................................... 6
Picture 9 - Driver installation progress ....................................................................................... 6
Picture 10 - Security Dialog ....................................................................................................... 7
Picture 11 - Driver Installation Success...................................................................................... 7
Picture 12 - FPA-5000 in device manager ................................................................................. 8

Page 1 of 8
Security Systems

From Our Reference Tel Fax Ottobrunn

Markus Ibba +498962901460 11.04.2013

Report
Issue Release 1.1
Topic FPA-5000 USB Driver Installation for Windows 7 and Windows 8

1 Introduction
Connecting a new hardware to a PC running Windows XP starts the hardware installation
wizard which guides you through the driver installation procedure. In contrary to that Windows 7
tries to find the driver automatically and may just complain with a small balloon message if any
needed driver is missing. To ease the driver installation with Windows 7 this guide describes it
step by step. It is valid for both, 32-Bit and 64-Bit systems. The difference is that any kernel
mode driver which shall be installed using Windows 7 64-Bit must be signed using a certificate
of a trusted authority (this is done for the USB driver of the FPA-5000). Please note that the
described procedure is also valid for Windows 8 32-Bit and 64-Bit.

2 Driver Installation
2.1 Prerequisites
The FPS-5000-RPS software is already installed on the system to ensure that the USB drivers
needed for the driver installation procedure are accessible. The FPA-5000 device is unplugged.

2.2 First Steps

Plug-in the FPA-5000 to a free USB port of the Windows 7 machine. As no suitable driver is
known to the system Windows 7 shows the following balloon messages:

Picture 1 - Installing Device Driver

Picture 2 - Driver Installation failed

Driver installation fails as not suitable driver can be found by the automatic driver installation
feature of Windows 7. Please note that those balloon messages disappear a few seconds later
removing any indication about the failure. If you’re fast enough you can click on the
corresponding icon in the taskbar which opens the following window:

Page 2 of 8
Security Systems

From Our Reference Tel Fax Ottobrunn

Markus Ibba +498962901460 11.04.2013

Report
Issue Release 1.1
Topic FPA-5000 USB Driver Installation for Windows 7 and Windows 8

Picture 3 - Driver installation failure dialog

Further note that those messages only appear once, that is if you unplug and plug-in you device
again no such balloon message will pop up. The installation just fails. Anyway continue by
opening the device manager in Windows 7 by selecting “Control Panel -> Administrative Tools -
> Computer Management”. There choose “Device Manager” from the tree on the left pane.
The device manager may look like this:

Picture 4 - Device Manager

An unknown device appears under the node “Other Devices”. In this case there is only one
unknown device – which is most likely the FPA-5000. If you have more than one unknown
device, just following the next steps – if not, continue with chapter 2.4.

2.3 Identifying the FPA-5000 device

Double-click on the first unknown device and select the “Details” Tab of the properties window
as shown below:

Page 3 of 8
Security Systems

From Our Reference Tel Fax Ottobrunn

Markus Ibba +498962901460 11.04.2013

Report
Issue Release 1.1
Topic FPA-5000 USB Driver Installation for Windows 7 and Windows 8

Picture 5 - Device Properties

Select “Hardware Ids” in the Property selection menu. There you should find an entry called:
“USB\VID_108C&PID_0113…”
If the number after VID is 108C (which is the vendor ID of Bosch) and the product id is 0113
(FPA-5000) the selected “unknown device” is the FPA-5000. Now close the properties dialog
and continue with chapter 2.4. If it does not identify the FPA-5000 continue with the next
unknown device and check the properties again doing so with all unknown devices until the FP-
5000 is found.

2.4 Installing the driver

Open the context menu of the unknown device identifying the FPA-5000 and choose “Update
Driver Software” as shown below:

Page 4 of 8
Security Systems

From Our Reference Tel Fax Ottobrunn

Markus Ibba +498962901460 11.04.2013

Report
Issue Release 1.1
Topic FPA-5000 USB Driver Installation for Windows 7 and Windows 8

Picture 6 - Update Driver Software

The following window opens:

Picture 7 - Install Driver for unknown device

Select the second option “Browse my computer for driver software – locate and install driver
software manually”. As a result the following dialog will be shown:

Page 5 of 8
Security Systems

From Our Reference Tel Fax Ottobrunn

Markus Ibba +498962901460 11.04.2013

Report
Issue Release 1.1
Topic FPA-5000 USB Driver Installation for Windows 7 and Windows 8

Picture 8 - Browse for driver

Browse for the FPA-5000 USB driver directory using the corresponding button and select the
USB folder of the FSP-5000-RPS software (e.g.: c:\FPS-5000-RPS\RAMV\USB). After selecting
the correct folder click “Next”. The following window appears:

Picture 9 - Driver installation progress

A few seconds later the following screen appears:

Page 6 of 8
Security Systems

From Our Reference Tel Fax Ottobrunn

Markus Ibba +498962901460 11.04.2013

Report
Issue Release 1.1
Topic FPA-5000 USB Driver Installation for Windows 7 and Windows 8

Picture 10 - Security Dialog

Here you can select whether to always trust software from Bosch Security Systems (check to
corresponding option). Click Install to continue installation of driver.
A few seconds later the driver installation is finished and the following window appears:

Picture 11 - Driver Installation Success

After the installation is finished check the device manager again. Now the FPA-5000 device
shall appear as shown below:

Page 7 of 8
Security Systems

From Our Reference Tel Fax Ottobrunn

Markus Ibba +498962901460 11.04.2013

Report
Issue Release 1.1
Topic FPA-5000 USB Driver Installation for Windows 7 and Windows 8

Picture 12 - FPA-5000 in device manager

Now the device is ready and can be used.

Page 8 of 8