Scribd
Upload
66 views3 pages

Edit Layout: 1. Create ULT Structure: Layout

This document provides instructions for creating a bridge model in MIDAS CIM. It involves 3 steps: 1. Create the bridge layout with 4 spans of 100 feet each and define the support locations. 2. Assign pre-defined unit structures from the library to each span, including PSC bridges, a PSC box, and abutments. 3. Modify the layout by applying a 400 foot radius curvature to spans 2 and 3.

Uploaded by

richard kwofie
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
66 views3 pages

Edit Layout: 1. Create ULT Structure: Layout

This document provides instructions for creating a bridge model in MIDAS CIM. It involves 3 steps: 1. Create the bridge layout with 4 spans of 100 feet each and define the support locations. 2. Assign pre-defined unit structures from the library to each span, including PSC bridges, a PSC box, and abutments. 3. Modify the layout by applying a 400 foot radius curvature to spans 2 and 3.

Uploaded by

richard kwofie
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

MIDAS CIM PSC Box Bridge

Edit Layout
1. Create ULT Structure : Layout

1. In Main Mode, Base Tab > Layout Editor


2. Enter Layout information, ID: 1 Name: Layout
3. Alignment Tap > Add 4 Span of 100 ft (100 ft, 100 ft, 100 ft, 100 ft)
4. Profile Tap > Set End Station to be 400 ft as there is no change in elevation profile
5. Cross Section Tap > : Support Type , Station (100ft , 200ft, 300ft) to set up support
location
6. use check button to create layout

37 https://www.midasuser.com
MIDAS CIM PSC Box Bridge

Edit Layout
2. Assign ULT Structure

1. In Main Mode, Structure > Library > Unit Structure > Assign
2. From Unit Structure list, Select library : PSC Bridge and assign unit structure by
selecting span 2 and add, repeat the step for span 3
3. From Unit Structure list, Select library : PSC Box and assign unit structure by
selecting span 1 and add, repeat the step for span 4
4. From Unit Structure list, Select library : Abutment and assign unit structure by
selecting layout with layoutwise on
5. use check button to create the bridge as assigned.

38 https://www.midasuser.com
MIDAS CIM PSC Box Bridge

Edit Layout
3. Modify Layout Editor

1. In Main Mode, Base Tab > Layout Editor


2. Load “Layout” from layout list
3. Alignment Tap > Apply curvature by changing type from Straight to Arc on Span
2,3 and entering Radius of 400 ft.
4. use check button to apply the curvature

3 3

39 https://www.midasuser.com

You might also like