Scribd
Upload
186 views2 pages

M DSE Pin Code ENG

Module PIN codes can be set using the module's PC software to control access. Upon leaving the factory, no PIN code is set and the module is fully accessible. The specific PC software used to set the PIN code depends on the module range. Once a PIN code is set, front panel editing and writing to the controller via PC software is blocked, while reading, viewing status, and control operations are still allowed. A forgotten or lost PIN code requires returning the module to the manufacturer for reset.

Uploaded by

Hayber Ferrer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
186 views2 pages

M DSE Pin Code ENG

Module PIN codes can be set using the module's PC software to control access. Upon leaving the factory, no PIN code is set and the module is fully accessible. The specific PC software used to set the PIN code depends on the module range. Once a PIN code is set, front panel editing and writing to the controller via PC software is blocked, while reading, viewing status, and control operations are still allowed. A forgotten or lost PIN code requires returning the module to the manufacturer for reset.

Uploaded by

Hayber Ferrer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Module PIN codes

• DESCRIPTION
Module pin codes are used to control access to the DSE Module itself. Upon leaving the factory, the
module DOES NOT have a PIN code set – The module is fully accessible.

• CONFIGURATION
To set the PIN code, use the module’s PC software.

Details on setting the PIN code within the controller are detailed in the respective PC Software manuals as detailed below:
MODULE RANGE PC SOFTWARE FOR PIN CODE EXAMPLE IMAGE
DSE 7300 Series 7000 series Configuration Suite (SCADA, MAINTENANCE)
DSE7200 Series
DSE6100 Series

DSE7500 Series Link7000Plus (SETUP, COMMS CONFIG, MODULE


SECURITY)

DSE5500 Series Link5000Plus (SETUP, COMMS CONFIG, MODULE


SECURITY)
DSE5300 Series 5xxx for Windows (SETUP, MODULE PIN)
DSE5200 Series 5xxx for Windows (SETUP, MODULE PIN)
Other DSE modules PIN Code Not Available

IF A PIN CODE IS SET YOU CANNOT : IF A PIN CODE IS SET YOU CAN STILL :
Gain access to the front panel editor (FPE) Use the PC software to READ FROM CONTROLLER
Use the PC software to WRITE TO CONTROLLER View SCADA INSTRUMENTATION and STATUS pages
Perform SCADA ‘CONTROL’ operations Control the module operating modes and view the module
instruments on the module fascia
Perform Modbus WRITE operations Perform Modbus READ operations

• IMPORTANT INFORMATION

o Once a PIN code has been set, it can be removed by changing it to “0000”or
changed to another PIN code as desired. You must enter the existing PIN code
first.
o There is no “back door” PIN code and there is no way to remove the PIN code
without knowing the current PIN code. If you lose or forget your PIN code, the
module must be returned to DSE to be reset. There will be a charge for this
service.

056-030 Module PIN codes Issue 1 – A.D.Manton


THIS PAGE IS INTENTIONALLY BLANK

056-030 Module PIN codes Issue 1 – A.D.Manton

You might also like