DM74LS367A Hex 3-STATE Buffer/Bus Driver

August 1986
Revised March 2000

DM74LS367A
Hex 3-STATE Buffer/Bus Driver
General Description
This device contains six independent gates each of which
performs a non-inverting buffer function. The outputs have
the 3-STATE feature. When enabled, the outputs exhibit
the low impedance characteristics of a standard LS output
with additional drive capability to permit the driving of bus
lines without external resistors. When disabled, both the
output transistors are turned OFF presenting a high-imped-
ance state to the bus line. Thus the output will act neither
as a significant load nor as a driver. To minimize the possi-
bility that two outputs will attempt to take a common bus to
opposite logic levels, the disable time is shorter than the
enable time of the outputs.

Ordering Code:
Order Number Package Number Package Description
DM74LS367AM M16A 16-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150 Narrow
DM74LS367AN N16E 16-Lead Plastic Dual-In-Line Package (PDIP), JEDEC MS-001, 0.300 Wide
Devices also available in Tape and Reel. Specify by appending the suffix letter “X” to the ordering code.

Connection Diagram Function Table

Y=A

Inputs Output
A G Y
L L L
H L H
X H Hi-Z
H = HIGH Logic Level
L = LOW Logic Level
X = Either LOW or HIGH Logic Level
Hi-Z = 3-STATE (Outputs are disabled)

© 2000 Fairchild Semiconductor Corporation DS006429 www.fairchildsemi.com

DM74LS367A
Absolute Maximum Ratings(Note 1)
Note 1: The “Absolute Maximum Ratings” are those values beyond which
Supply Voltage 7V the safety of the device cannot be guaranteed. The device should not be
operated at these limits. The parametric values defined in the Electrical
Input Voltage 7V Characteristics tables are not guaranteed at the absolute maximum ratings.
Operating Free Air Temperature Range 0°C to +70°C The “Recommended Operating Conditions” table will define the conditions
for actual device operation.
Storage Temperature Range −65°C to +150°C

Recommended Operating Conditions

Symbol Parameter Min Nom Max Units
VCC Supply Voltage 4.75 5 5.25 V
VIH HIGH Level Input Voltage 2 V
VIL LOW Level Input Voltage 0.8 V
IOH HIGH Level Output Current −2.6 mA
IOL LOW Level Output Current 24 mA
TA Free Air Operating Temperature 0 70 °C

Electrical Characteristics
over recommended operating free air temperature range (unless otherwise noted)
Typ
Symbol Parameter Conditions Min Max Units
(Note 2)
VI Input Clamp Voltage VCC = Min, II = −18 mA −1.5 V
VOH HIGH Level VCC = Min, IOH = Max
2.4 3.4 V
Output Voltage VIL = Max, VIH = Min
VOL LOW Level VCC = Min, IOL = Max
0.35 0.5
Output Voltage VIL = Max, VIH = Min V
IOL = 12 mA, VCC = Min 0.25 0.4
II Input Current @ Max Input Voltage VCC = Max, VI = 7V 0.1 mA
IIH HIGH Level Input Current VCC = Max, VI = 2.7V 20 µA
IIL LOW Level VCC = Max, VI = 0.5V (Note 5) A Input −20 µA
Input Current VCC = Max, VI = 0.4V (Note 6) A Input −0.4
mA
VCC = Max, VI = 0.4V G Input −0.4
IOZH Off-State Output Current with VCC = Max, VO = 2.4V
20 µA
HIGH Level Output Voltage Applied VIH = Min, VIL = Max
IOZL Off-State Output Current with VCC = Max, VO = 0.4V
−20 µA
LOW Level Output Voltage Applied VIH = Min, VIL = Max
IOS Short Circuit Output Current VCC = Max (Note 3) −20 −100 mA
ICC Supply Current VCC = Max (Note 4) 14 24 mA
Note 2: All typicals are at VCC = 5V, TA = 25°C.
Note 3: Not more than one output should be shorted at a time, and the duration should not exceed one second.
Note 4: ICC is measured with the DATA inputs grounded and the OUTPUT CONTROLS at 4.5V.
Note 5: Both G inputs are at 2V.
Note 6: Both G inputs at 0.4V.

Switching Characteristics
at VCC = 5V and TA = 25°C
RL = 667Ω
Symbol Parameter CL = 50 pF CL = 150 pF Units
Min Max Min Max
tPLH Propagation Delay Time LOW-to-HIGH Level Output 16 25 ns
tPHL Propagation Delay Time HIGH-to-LOW Level Output 16 25 ns
tPZH Output Enable Time to HIGH Level Output 30 40 ns
tPZL Output Enable Time to LOW Level Output 30 40 ns
tPHZ Output Disable Time from HIGH Level Output (Note 7) 20 ns
tPLZ Output Disable Time from LOW Level Output (Note 7) 20 ns
Note 7: CL = 5 pF.

www.fairchildsemi.com 2
 DM74LS367A
Physical Dimensions inches (millimeters) unless otherwise noted

16-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150 Narrow
Package Number M16A

3 www.fairchildsemi.com
DM74LS367A Hex 3-STATE Buffer/Bus Driver
Physical Dimensions inches (millimeters) unless otherwise noted (Continued)

16-Lead Plastic Dual-In-Line Package (PDIP), JEDEC MS-001, 0.300 Wide

Package Number N16E

Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and
Fairchild reserves the right at any time without notice to change said circuitry and specifications.
LIFE SUPPORT POLICY

FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT
DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD
SEMICONDUCTOR CORPORATION. As used herein:
1. Life support devices or systems are devices or systems 2. A critical component in any component of a life support
which, (a) are intended for surgical implant into the device or system whose failure to perform can be rea-
body, or (b) support or sustain life, and (c) whose failure sonably expected to cause the failure of the life support
to perform when properly used in accordance with device or system, or to affect its safety or effectiveness.
instructions for use provided in the labeling, can be rea-
sonably expected to result in a significant injury to the www.fairchildsemi.com
user.

www.fairchildsemi.com 4