Scribd
Upload
87 views4 pages

Adjustable Frequency Drives and Power Factor Correction Capacitors

EATON

Uploaded by

Shailesh Chetty
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
87 views4 pages

Adjustable Frequency Drives and Power Factor Correction Capacitors

EATON

Uploaded by

Shailesh Chetty
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

Application Note AP040002EN Effective August 2013

Adjustable Frequency Drives and Power Factor


Correction Capacitors

Application Summary
Capacitor banks provide distribution and transmission circuits with power factor correction, reduced KVA
demand and billing and improved voltage regulation. They can be switched in and out based on load
conditions. While this practice is intended to provide quality power, with the increase use of electronic
power equipment it may actually be blamed for poor quality power.

Capacitor Bank Switching Transients


A momentary short circuit is created each time a capacitor bank is switched on as energy is absorbed
from the line to charge the capacitor. This results in a sudden drop in voltage followed by voltage ringing.
The magnitude and frequency of the ringing is a function of the power distribution network. The over
voltage can range from 1.2-1.6 time the nominal peak voltage with ringing frequencies between 400-600
Hz.

DC Bus Response to Switching Transients


The AFD’s DC bus capacitors attempt to charge to the peak of the transient line voltage, resulting in an
over voltage fault or possibly damage to the input diode front-end. Over voltage trips at the same time of
day are symptomatic of this condition. This may happen early in the morning when capacitors are
Application Note AP040002EN AFDs and PF Correction Capacitors
Effective August 2013

switched in response to increased load demand. Alternately, over voltage trips may result from starting
large motor loads and power factor correction capacitors within the facility. The smaller the AFD and
lighter the load, the more susceptible they are to over voltage tripping due to capacitor switching transi-
ents.

Influence of AC Line Reactors


AC Line Reactors are the AFD’s first line of defense against capacitor switching transients as they pro-
vide some voltage drop as well as a limit to surge current. The required reactance depends on the source
impedance, transient magnitude and trip level of the drive. A 3% reactor based on the drive’s kVA rating
normally does the job. However, when the over voltage transient is greater than 1.6 times nominal volt-
age, a 5% reactor may be required. When an AFD is powered but not running, then even a line reactor
may not solve the problem. This is because the AFD does not draw any line current and the excess ener-
gy from the surge event cannot be transferred to the connected motor load.

2 EATON CORPORATION www.eaton.com


Application Note AP040002EN Document title (match page 1)
Effective Month 2013

Surge-protective Device and Switching Transients


Surge-protective devices are not a good solution to the capacitor-switching transients. These devices
have a higher clamping voltage than the switching transients. If surge-protective devices are selected with
a low clamping voltage, they are likely to become the point of failure due to insufficient energy-handling
capability.

Resonance of Harmonic Currents


Capacitor banks in distribution systems with 6 pulse AFDs may result in undesirable resonant currents.
Capacitors can amplify harmonics if a parallel resonance condition exists between the capacitor bank and
the harmonic frequencies generated by the AFDs. The result would be excessive capacitor currents, ca-
pacitor fuse blowing, and excessive voltage distortion on the system bus. It is important to note that the
capacitors themselves do not create harmonics, but can serve to amplify them if system conditions are
right.
Additional Help
In the US or Canada: please contact the Technical Resource Center at 1-877-ETN-CARE
or 1-877-326-2273 option 2, option 6.

All other supporting documentation is located on the Eaton web site at www.eaton.com/Drives

Eaton
1000 Eaton Boulevard
Cleveland, OH 44122 USA
Eaton.com

© 2013 Eaton Eaton is a registered trademark


All Rights Reserved of Eaton Corporation.
Printed in USA
Publication No. AP040002EN All other trademarks are property
Month 2013 of their respective owners

You might also like