0% found this document useful (0 votes)
49 views2 pages

Experiment Multisim Procedures

The document describes several electronics experiments using diodes and circuits. Experiment 2 observes how the output of a circuit with a diode limiter varies as resistance is changed. Experiment 3 examines the effect of varying resistance in a diode clamper circuit operating at 40Vp and 200Hz. Experiment 5 involves constructing a voltage doubler circuit and measuring the peak output voltage. Experiment 6 looks at how the output voltage of a circuit with a Zener diode is regulated as resistance is varied.

Uploaded by

ArvinAL
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
49 views2 pages

Experiment Multisim Procedures

The document describes several electronics experiments using diodes and circuits. Experiment 2 observes how the output of a circuit with a diode limiter varies as resistance is changed. Experiment 3 examines the effect of varying resistance in a diode clamper circuit operating at 40Vp and 200Hz. Experiment 5 involves constructing a voltage doubler circuit and measuring the peak output voltage. Experiment 6 looks at how the output voltage of a circuit with a Zener diode is regulated as resistance is varied.

Uploaded by

ArvinAL
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Experiment 2: Diode Limiters

Make the circuit below, observe the output while the resistance is being varied.

Experiment 3: Diode Clampers

1. Make the circuit below

2. Set the supply to 40Vp and 200 Hz


3. Vary the potentiometer’s resistance and see the effect of the resistance
4. Observe the output

Experiment 5: Voltage Doubler

1. Make the circuit below


2. Set the meter reading of the Voltmeter 2 into DC, convert the reading into peak.
3. Observe the output

Experiment 6: Zener and Voltage Regulation

1. Make the circuit

2. Observe the output voltage while you vary the resistance

You might also like