0% found this document useful (0 votes)
161 views5 pages

Circuitrix Ece

The fundamental time period of the signal f(t) = 1 + 2 cos(πt) + 3 sin(2πt/3)+ 4cos(π/2t+ π/4) is 1 second. A linear Hamming code maps the 4-bit message "0001" to the 7-bit codeword "0000111" and the message "0011" to "1100110", so the message "0010" would be mapped to "1100001". The minimum number of 2-to-1 multiplexers required to realize a 4-to-1 multiplexer is 2.

Uploaded by

Jeevan Sai Maddi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
161 views5 pages

Circuitrix Ece

The fundamental time period of the signal f(t) = 1 + 2 cos(πt) + 3 sin(2πt/3)+ 4cos(π/2t+ π/4) is 1 second. A linear Hamming code maps the 4-bit message "0001" to the 7-bit codeword "0000111" and the message "0011" to "1100110", so the message "0010" would be mapped to "1100001". The minimum number of 2-to-1 multiplexers required to realize a 4-to-1 multiplexer is 2.

Uploaded by

Jeevan Sai Maddi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

1.

Consider the signal f(t) = 1 + 2 cos(πt) + 3 sin(2πt/3)+ 4cos(π/2t+ π/4) where t is


in seconds. Its fundamental time period, in seconds, is _______.

2. Latch is a device with how many stable states ? a. 1 b.2 c.3 d.infinite

3. A linear Hamming code is used to map 4-bit messages to 7-bit codewords. The
encoder mapping is linear. If the message 0001 is mapped to the codeword
0000111, and the message 0011 is mapped to the codeword 1100110, then the
message 0010 is mapped to

(a) 1100001 (b) 1111000 (c) 0010011 (d) 1111111


4. Bridge rectifier is an alternative for
a. full wave rectifier b. half wave rectifier c. Peak rectifier d. None

5. Radiation resistance of a small dipole current element of length ℓ at a frequency


of 3 GHz is 3 ohms. If the length is changed by 1%, then the percentage change in
the radiation resistance, rounded off to two decimal places, is ________ %
6. A decimal counter has how many states. a.5 b.10 c.15 d.2
7.In which of the filter circuits given below, will the bandwidth be equal to critical
frequency? A.low pass B.high pass c.band pass d. band-stop

8. Consider a stable LTI system that is provided with a sinusoidal input having a
frequency of 10 Hz. Then the corresponding steady state output would be a
sinusoidal having a frequency of
a.5Hz b.10Hz c.15Hz d.20Hz

9. The minimum number of 2-to-1 multiplexers required to realize a 4-to-1


multiplexer is
10. An overflow occurs in which position a. MSB b. LSD c. middle d. signed
11.For a transistor α is 0.98. Find its common emitter and common collector
configuration gains.
12. If either the inductance or rate of change of current is doubled, the induced emf
a. Remains constant b. becomes zero c. doubles d. becomes half
13.Octal to binary conversion : (24) 8 =? A. (111101)2 B. (010100)2
C.(111100)2 D.(101010)2
14. An overflow occurs in which position a. MSB b. LSD c. middle d. signed
15.A system which is linear is said to obey the rules of a. addivity b. homogenity
c. both a & b d. none 14. A semiconductor element is which element
a.bilateral b.unilateral c. active d. passive
16.A rectangular waveguide of width w and height h has cut-off frequencies for
TE10 and TE11 modes in the ratio 1:2. The aspect ratio w/h, rounded off to two
decimal places, is ______
17. In a 4-bit ripple carry adder, the full adder takes 3ns and 2ns to produce sum
and carry outputs respectively. The inputs to this adder are FH and 1H and are
applied at time t = 0.At ____ nsec, the output of the adder is 8H.

18.The velocity of sound waves in air is a.constant at all temperatures b.varies


directly as temperature c.varies inversely as absolute temperature d.varies directly
as square root of absolute temperature
19.Which of the following amplifier has the highest input impedance? a.CE b.CB
c.CC d.none
20.If g(t) = e- p t2 then G(0) is __________ (where g(t)⇔ G(f) )
a.1 b.2 c.infinity d.none
21.The steady state error of a stable type 0 unity feedback system for a unit step
function is : a. b.1 c.0 d.infinity
22.How many maximum number of functions can be defined with two symbols
which are Boolean in nature: a.2 b.4 c.8 d.16
23. Which of the following diode does not show non-linear V-I characteristics?
a.thermistor b.schottky c.tunnel d.p-n junction
24. Which of the following is a circularly polarized antenna? A.horn B.dipole
C.helical D.pyramidal
25.Latch is which triggered? A.level B.edge C.Both D.none
26.Three resistance of 15Ω each are connected in delta. The resistance of
equivalent star will have a value of

(a) 12Ω (b) 5Ω (c) 5/3Ω (d) 45Ω

27. Which among the below mentioned devices acts as a driver in CMOS Inverter
Circuit?

a. PMOS b. NMOS c. Both a and b d. None of the above

28. Where should be the position of Q point on the load line, if the transistor is
used for amplification purpose?

a. At the point of inception (initial point) b. At the centre


c. At the eventual point (final point) d. None of the above

29. Two Two-port networks are connected in cascade. The combination is to the
represented as a single two – port network, by multiplying the individual

(a) z-parameter matrices (b) h-parameter matrices (c) y-parameter matrices (d)
ABCD parameter

30.The capacitance per unit length and the characteristic impedance of a lossless
transmission line are C and Z0 respectively. The velocity of a travelling wave on
the transmission line is

(a) Z0C (b)1/(Z0C) (c) Z0/C (d)C/Z0

31. Which of the following components are used for bias compensation in
transistor circuit

(a) resistors (b) rectifier diodes (c) thermistors (d) both (b) and (c) above

32. Improper biasing of the transistor circuit leads to

(a) excessive heat production at collector terminal (b) distortion in output signal

(c) faulty location of load line (d) heavy loading of emitter terminal

33.Avalanche breakdown in a diode occurs when

a. Potential barrier is reduced to zero. b. Forward current exceeds certain value c.


Reverse bias exceeds a certain value. d. None of these

34. When the PN junction is forward biased the sequence of events that take place
are :

a. Diffusion, drift and recombination b. Injection, diffusion and recombination.

c. Diffusion, injection and drift. d. None of the above.

35. A transmission line of 50 Ω characteristic impedance is terminated with a 100


Ω resistance. The minimum impedance measured on the line is equal to
(a) 0 Ω (b)25 Ω (c) 50 Ω (d)100
36. IC(Instruction cycle),FC(Fetch Cycle) and EC(Execute Cycle) are related as

a. IC=FC-EC b. IC=FC+EC c. IC=FC+2EC d. EC=IC+EC

37. A 256 x4 EPROM has

a. 8addresspins&4datapins b. 4address pins&8datapins

38. For a base current of 10uA what is the value of collector current is common

emitter if fdc=100

a. 10uA b. 100uA c. 1mA d. 10Ma

39. which power amplifier can deliver maximum load amplifier

a. classA b. classAB c. classB d. classC

40.The most commonly used semiconductor material is

a. silicon b. germanium c. both a and b d. none of the above

41. In an n channel JFET the gate is

a. n type b. p type c. partially p and n d. none of the above

42. In the expression A+BC, the total no of minterms used are?

a. 2 b. 3 c. 4 d. 5

43. Which of the following is the fastest logic?

a. TTL b. ECL c. CMOS d. RTL

44. Which of the following oscillator is suitable for sequence in the range of
MGHZ

a. ring b. weinbridge c. hartley d. both a&b

45. An energy signal has g(f)=10 it’s energy spectrum density is

a. 10 b. 100 c. 50 d. 10

You might also like