Watch Out For Those Electrical Arcs!: 5-Minute Safety Talk by Osha Pros

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

5-MINUTE SAFETY TALK by OSHA Pros

Watch Out For Those Electrical Arcs!

The potential danger of getting shocked isn’t the only peril when
working in an environment with electrical devices. Arcs are
miniscule, spark-like upsurges of voltage that occur when a current’s
flow is disrupted, such as in the occasion of a short circuit. Below is
information on how hazardous arcs can be and how to avoid them.

Arc Hazards
Arcs take place when there has been damage to cord-insulation, bad
wiring, or short-circuit. When the current is strong enough, the
resulting arc is known to be responsible for shocking, burning, and
even in some ignition of a fire. If you work in a place with volatile
gases, mists, or other small fibers, even the smallest of arcs can
result in extremely severe explosions.

Arc Prevention
Insulation, the covering for electrical-wires and what is responsible
for encasing the live wires on certain apparatuses, allows the flow of
currents to be blocked out, protecting against arcs. In order to be
efficacious, however, the insulation has to be correct for the electrical current and should always be
maintained and kept away from moisture. Check the insulation every time prior to each use. You should
always ensure that power cords are safe and undamaged, but in the case that they are, be sure to replace
them. Two ways to ensure safety are to keep your feet off of the cords and to not let them near sharp
edges

Working Wet
Dealing with electrical equipment in moist and wet environments can be a cause of extreme hazard.
Water charges the current of electricity and lessens the efficacy of insulation. If utilizing the electrical
apparatus in wet conditions is a must, use double-insulation and a GFCI (short for: Ground Fault
Circuit Interrupter). Do not let the cord come into contact with the water and make sure you are dry
when handling the equipment.

Practice Basic Safety


General practice of precautionary techniques will assist in preventing the occurrence of arcs and lessen
the threat of physical harm if they happen by chance. Check the equipment for damage and report as
soon as you notice any abnormalities or unstable wiring connections. Work with only grounded
accessories and tools and install them only into grounded electrical outlets. If you treat electricity
cautiously, your work environment will become much less dangerous for you and those around.
Safety Meetings/Training Sign In Sheet
Company Name: ____________________________________________________________

Date of Meeting: ____________________ Instructor: _________________________

Topic: _____________________________________________________________________

Attending Employees

Print Name (Write Legibly) Signature


1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24

You might also like