Scribd
Upload
52 views

UV-5R.c Om: Radio Should Now Operate The Repeater If in Range

The document provides instructions to program a radio to access a repeater with the following settings: - Receive frequency of 146.985 MHz - Minus 600 Hz offset - 100 Hz CTCSS tone - Low power level - Wide bandwidth transmit - Channel #010 The instructions include pressing various menu and number buttons to input the settings into the radio.

Uploaded by

tom
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
52 views

UV-5R.c Om: Radio Should Now Operate The Repeater If in Range

The document provides instructions to program a radio to access a repeater with the following settings: - Receive frequency of 146.985 MHz - Minus 600 Hz offset - 100 Hz CTCSS tone - Low power level - Wide bandwidth transmit - Channel #010 The instructions include pressing various menu and number buttons to input the settings into the radio.

Uploaded by

tom
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

T o program repeater 146.

985, m inus 600 Hz offset, 100 Hz C T C SS tone, low power level, w id e b an d tran sm it,
in to C h ann el #010
T urn on radio. Radio will announce Frequency Mode or Channel Mode. If required, press VFO /M R to enter Frequency
M ode. If required, Press A/B to select upper display and Press BAN D to choose the VH F range instead of UH F range.
T urn off dual-watch. MEN U + 7 + M EN U . U se the • – key to select O FF. Press MEN U + EXIT

Press [MENU ] + 1 + [MEN U ] U se the • – key to select 5 KH z Step


Press [M EN U ] + [EXIT ] T o accept and exit

m
Enter 146.985 T he receive frequency

o
Press [MENU ] + 25 + [MEN U ] U se the • – key to select Minus O ffset (-)
Press [M EN U ] + [EXIT ] T o accept and exit

. c
Press [MENU ] + 26 + [MEN U ] U se the • – key to select 00.600 H z O ffset

R
O r use Keypad and enter 00.600 H z O ffset
Press [M EN U ] + [EXIT ] T o accept and exit

5
U se the • – key to select 100.0 Hz T one

-
Press [MENU ] + 1 + 3 + [MEN U ]
O r use Keypad and enter 100.0

V
Press [M EN U ] + [EXIT ] T o accept and exit
U se the • – key to select Low Power

U
Press [MENU ] + 2 + [MEN U ]
Press [M EN U ] + [EXIT ] T o accept and exit
Press [MENU ] + 5 + [MEN U ] U se the • – key to select W ide Bandwidth
Press [M EN U ] + [EXIT ] T o accept and exit
Radio should now operate the repeater if in range
Press [MENU ] + 2 + 7 + [MEN U ] Enter 010 or U se the • – key to select 010
Press [ME N U ] + [EXIT ] T his stores the R eceive Frequency
Press [*SC AN ] (quick press) D isplay will show T ransmit Frequency
Press [MENU ] + 2 + 7 + [MEN U ] Enter 010 (if required)
Press [ME N U ] + [EXIT ] T his stores the T ransmit Frequency
This method devised by Buddy Brannan (KB5ELV), author of The Eyes-Free Manual

You might also like