Separable Equations and

Module 7: 
Homogeneous Equations
In Section 1.2 we used a process of direct integration to solve first order linear equations of the form

  (1)

where   and   are constants. We will now show that this process is actually applicable to a much larger class
of equations.
We will use  , rather than  , to denote the independent variable in this section for two reasons. In the first
place, different letters are frequently used for the variables in a differential equation, and you should not
become too accustomed to using a single pair. In particular,   often occurs as the independent variable.
Further, we want to reserve   for another purpose later in the section.
The general first order equation is

  (2)

Linear equations were considered in the preceding section, but if Eq. (2) is nonlinear, then there is no
universally applicable method for solving the equation. Here, we consider a subclass of first order equations
that can be solved by direct integration.
To identify this class of equations, we first rewrite Eq. (2) in the form

  (3)

It is always possible to do this by setting   and  , but there may be other

ways as well. If it happens that   is a function of   only and   is a function of   only, then Eq. (3) becomes

  (4)

Such an equation is said to be separable, because if it is written in the differential form

  (5)
then, if you wish, terms involving each variable may be placed on opposite sides of the equation. The
differential form (5) is also more symmetric and tends to suppress the distinction between independent and
dependent variables.
A separable equation can be solved by integrating the functions   and  . We illustrate the process by an
example and then discuss it in general for Eq. (4).

E X AM P LE   1 
Show that the equation

  (6
)
is separable, and then find an equation for its integral curves.
If we write Eq. (6) as

  (7
)
then it has the form (4) and is therefore separable. Recall from calculus that if   is a function of  , then by
the chain rule,

For example, if  , then

Thus the second term in Eq. (7) is the derivative with respect to   of  , and the first term is the
derivative of  . Thus Eq. (7) can be written as

or

Therefore, by integrating, we obtain

  (8
)
where   is an arbitrary constant. Equation (8) is an equation for the integral curves of Eq. (6). A direction
field and several integral curves are shown in Figure 2.2.1. Any differentiable function   that
satisfies Eq. (8) is a solution of Eq. (6). An equation of the integral curve passing through a particular
point   can be found by substituting   and   for   and  , respectively, in Eq. (8) and determining
the corresponding value of  .
 FIGURE 2.2.1   
Direction field and integral curves of  .
Essentially the same procedure can be followed for any separable equation. Returning to Eq. (4), let   
and   be any antiderivatives of   and  , respectively. Thus

  (9)
and Eq. (4) becomes

  (10)

If   is regarded as a function of  , then according to the chain rule,

  (11)

Consequently, we can write Eq. (10) as

  (12)

By integrating Eq. (12), we obtain

  (13)

where   is an arbitrary constant. Any differentiable function   that satisfies Eq. (13) is a solution of
Eq. (4); in other words, Eq. (13) defines the solution implicitly rather than explicitly. In practice, Eq. (13) is
usually obtained from Eq. (5) by integrating the first term with respect to   and the second term with respect
to  . The justification for this is the argument that we have just given.
The differential equation (4), together with an initial condition
   (14)
forms an initial value problem. To solve this initial value problem, we must determine the appropriate value for
the constant   in Eq. (13). We do this by setting   and   in Eq. (13) with the result that

  (15)
Substituting this value of   in Eq. (13) and noting that

we obtain

  (16)

Equation (16) is an implicit representation of the solution of the differential equation (4) that also satisfies the
initial condition (14). Bear in mind that to determine an explicit formula for the solution, you need to solve Eq.
(16) for   as a function of  . Unfortunately, it is often impossible to do this analytically; in such cases you can
resort to numerical methods to find approximate values of   for given values of  .

E X AM P LE   2 
Solve the initial value problem

  (17)

and determine the interval in which the solution exists.

The differential equation can be written as

Integrating the left side with respect to   and the right side with respect to   gives

  (18)
where   is an arbitrary constant. To determine the solution satisfying the prescribed initial condition, we
substitute   and   in Eq. (18), obtaining  . Hence the solution of the initial value problem
is given implicitly by

  (19)
To obtain the solution explicitly, we must solve Eq. (19) for   in terms of  . That is a simple matter in this
case, since Eq. (19) is quadratic in  , and we obtain

  (20)

Equation (20) gives two solutions of the differential equation, only one of which, however, satisfies the given
initial condition. This is the solution corresponding to the minus sign in Eq. (20), so we finally obtain

  (21)

as the solution of the initial value problem (17). Note that if we choose the plus sign by mistake in Eq. (20),
then we obtain the solution of the same differential equation that satisfies the initial condition  .
Finally, to determine the interval in which the solution (21) is valid, we must find the interval in which the
quantity under the radical is positive. The only real zero of this expression is  , so the desired
interval is  . Some integral curves of the differential equation are shown in Figure 2.2.2. The black
curve passes through the point   and thus is the solution of the initial value problem (17). Observe
that the boundary of the interval of validity of the solution (21) is determined by the point   at which
the tangent line is vertical.

FIGURE 2.2.2   Integral curves of  ; the solution satisfying   

is shown in black and is valid for  .

E X AM P LE   3 
Solve the equation

  (22)

and draw graphs of several integral curves. Also find the solution passing through the point   and
determine its interval of validity.
Rewriting Eq. (22) as
integrating each side, multiplying by 4, and rearranging the terms, we obtain

  (23)

where   is an arbitrary constant. Any differentiable function   that satisfies Eq. (23) is a solution of
the differential equation (22). Graphs of Eq. (23) for several values of   are shown in Figure 2.2.3.

FIGURE 2.2.3   Integral curves of  . The solution passing through   is

shown by the black curve.
To find the particular solution passing through  , we set   and   in Eq. (23) with the result
that  . Thus the solution in question is given implicitly by

  (24)
It is shown by the black curve in Figure 2.2.3. The interval of validity of this solution extends on either side
of the initial point as long as the function remains differentiable. From the figure we see that the interval ends
when we reach points where the tangent line is vertical. It follows from the differential equation (22) that

these are points where  , or  . From Eq. (24) the corresponding values
of   are  . These points are marked on the graph in Figure 2.2.3.

Note 1: Sometimes an equation of the form (2)

has a constant solution  . Such a solution is usually easy to find because if   for some
value   and for all  , then the constant function   is a solution of the differential equation (2). For
example, the equation
   (25)

has the constant solution  . Other solutions of this equation can be found by separating the variables and
integrating.
Note 2: The investigation of a first order nonlinear equation can sometimes be facilitated by regarding both   
and   as functions of a third variable  . Then

  (26)

If the differential equation is

  (27)

then, by comparing numerators and denominators in Eqs. (26) and (27), we obtain the system

  (28)
At first sight it may seem unlikely that a problem will be simplified by replacing a single equation by a pair of
equations, but in fact, the system (28) may well be more amenable to investigation than the single equation
(27). Chapter 9 is devoted to nonlinear systems of the form (28).
Note 3: In Example 2 it was not difficult to solve explicitly for   as a function of  . However, this situation is
exceptional, and often it will be better to leave the solution in implicit form, as in Examples 1 and 3. Thus, in
the problems below and in other sections where nonlinear equations appear, the words “solve the following
differential equation” mean to find the solution explicitly if it is convenient to do so, but otherwise to find an
equation defining the solution implicitly.

PROBLEMS
In each of Problems 1 through 8, solve the given differential equation.
1.  
2.  

3.  
4.  

5.  

6.  

7.  

8.  

In each of Problems 9 through 20:

(a)  Find the solution of the given initial value problem in explicit form.
  9.  

 10.  

 11.  

 12.  

 13.  

 14.  

 15.  

 16.  

 17.  

 18.  

 19.  

 20.  

Homogeneous Equations. If the right side of the equation   can be expressed as a function
of the ratio   only, then the equation is said to be homogeneous.
1
The word “homogeneous” has different meanings in different mathematical contexts. The homogeneous equations
 considered here have nothing to do with the homogeneous equations that will occur in Chapter 3 and elsewhere.

Such equations can always be transformed into separable equations by a change of the dependent variable.
Problem 30 illustrates how to solve first order homogeneous equations.
 30.  Consider the equation
   (i)

(a)  Show that Eq. (i) can be

rewritten as

  (ii)

thus Eq. (i) is homogeneous.

(b)  Introduce a new dependent variable   so that  , or  . Express   in terms
of  ,  , and  .
(c)  Replace   and   in Eq. (ii) by the expressions from part (b) that involve   and  . Show
that the resulting differential equation is

or

  (iii)

Observe that Eq. (iii) is separable.

(d)  Solve Eq. (iii), obtaining   implicitly in terms of  .
(e)  Find the solution of Eq. (i) by replacing   by   in the solution in part (d).

(f)  Draw a direction field and some integral curves for Eq. (i). Recall that the right side of Eq. (i) actually
depends only on the ratio  . This means that integral curves have the same slope at all points on
any given straight line through the origin, although the slope changes from one line to another.
Therefore, the direction field and the integral curves are symmetric with respect to the origin. Is this
symmetry property evident from your plot?
The method outlined in Problem 30 can be used for any homogeneous equation. That is, the
substitution   transforms a homogeneous equation into a separable equation. The latter equation can
be solved by direct integration, and then replacing   by  gives the solution to the original equation. In each
of Problems 31 through 38:
(a)  Show that the given equation is homogeneous.

(b)  Solve the differential equation.

(c)  Draw a direction field and some integral curves. Are they symmetric with respect to the origin?
  31.  

 32.  

 33.  
 34.  

 35.  

 36.  

 37.  

 38.  

Copyright © 2013 John Wiley & Sons, Inc. All rights reserved.