A B C A B C A B C A B C

1 1 1 1
2 2 2
5
ACU
S

2.88

2.88
W1 W1 W1 W1
S S2 2

S2 S 2 2
2 2 2 2
2
W2 W1 W2 W1
S
1
S 2
3 3 3 3
PB S PB 3
2
2

2
S2 4

3.04
3.03

3.03

3.03
W1 W1 W1 W1
2
S

4 S2 S3 2 2
4 4 4

CARPORT CARPORT

1 GROUND FLOOR LIGHTING LAYOUT

________________________________________________________________________ 2 SECOND FLOOR LIGHTING LAYOUT
________________________________________________________________________ 3 GROUND FLOOR POWER LAYOUT
________________________________________________________________________ 4 SECOND FLOOR POWER LAYOUT
________________________________________________________________________
E-1 SCALE: NTS E-1 SCALE: NTS E-1 SCALE: NTS E-1 SCALE: NTS

1. ALL ELECTRICAL WORKS HEREIN SHALL BE DONE WITH THE

SERVICE REQUIREMENTS OF THE LATEST PROVISIONS OF THE PHILIPPINE

ELECTRICAL CODE, EXISTING APPLICABLE ORDINANCES OF
THE LOCAL GOVERNMENT AND THE REQUIREMENTS OF THE
ENTRANCE LOCAL POWER COMPANY.

2. SERVICE POWER FROM LOCAL POWER COMPANY SHALL BE

SINGLE - PHASE, 220 V, 2 WIRE, 60 HERTZ, AC.

3. ALL WIRINGS SHALL BE INSTALLED IN STANDARD UNPLASTICIZED

POLYVINYL CHLORIDE(UPVC) CONDUITS, RUN EMBEDDED INSIDE
THE CONCRETE AND HOLLOW BLOCKS, STRUCTURES, SLABS,
SCHEDULE OF LOADS COLUMNS, WALLS PARTITIONS, AND/ORRUN CONCEALED BETWEEN
DOUBLE - WALL WOODEN PARTITION AND IN - SIDE THE CEILING SPACES.

NO. OF SWITCHES LEGEND : 4. UNLESS OTHERWISE NOTED ON THE PLAN, THE MINIMUM SIZE OF
CIRCUIT LOAD DESCRIPTION VA AMPS VOLTS CONDUCTOR SIZE CONDUIT SIZE CIRCUIT WIRE AND CONDUIT SHALL BE 2.0 mm² THW AND 20 mmØ RESPECTIVELY.
OUTLETS KWHr Meter
NO. S S2 S3 BREAKER M SYMBOL DESCRIPTION 5. WHENEVER REQUIRED AND NECESSARY, PULL BOXES OR JUNCTION
1 Lighting Outlet 10 1000 4.35 230 2
2-2.0 mm THW Copper wire 20 mm PVC 3 2 1 15 AT, 2P BOXES OF PROPER SIZES SHALL BE INSTALLED AT CONVENIENT AND
2 Panel Board INCONSPICIUOS LOCATIONS ALTHOUGH SUCH BOXES ARE NOT SHOWN
2 Lighting Outlet 8 800 3.48 230 2-2.0 mm THW Copper wire 20 mm PVC 4 2 0 15 AT, 2P
3 Convenience Outlet 6 4.70 230 2-3.5 mm2 +1-2.0mm THW Copper wire 20 mm PVC 20 AT, 2P
1 Circuit Homerun ON THE PLAN NOR MENTIONED IN THE SPECIFICATIONS.
1080
4 Convenience Outlet 7 1260 5.48 230 2-3.5 mm 2+1-2.0mm2 THW Copper wire 20 mm PVC 20 AT, 2P
2-8.0 mm² in 20 mm Ø uPVC LED Pin Light 6. ALL OUTLETS SHALL BE INSTALLED AT THE FOLLOWING HEIGHTS
ABOVE THE FINISH FLOOR LEVEL UNLESS OTHERWISE NOTED:
5 Air Conditioning Unit 1 2300 10.0 230 2-3.5 mm 2+1-2.0mm2 THW Copper wire 20 mm PVC 20 AT, 2P Wall LED Light
PB WALL SWITCHES 1.40 M
6 Spare 1 1500 6.52 230 Empty 20 mm PVC 20 AT, 2P ACU Air Conditioning Unit CONVENIENCE OUTLETS 0.30 M
TOTAL: 7940 34.53 230 2-8.0 mm +1-5.0mm2THW Copper wire 20 mm PVC 50AT, 2P 50 AT 2

Duplex Convenience Outlet 7. MINIMUM SIZE OF CONDUIT AND CONDUCTORS SHALL BE AS FOLLOWS:
A. 20 mmØ FOR THICK WALL UNPLASTICIZED POLYVINYL CHLORIDE
1 2 Sx Single Pole Switch (UPVC) CONDUIT TUBING
I = [6224 VA + (0.25)(2300 VA)]/230 V I = [3000 VA + 924 VA + (250%)(2300 VA)]/230 V 15 AT 15 AT Sxy Duplex Pole Switch C. 2.0 mm² THW COPPER WIRE FOR LIGHTING
I = 29.56 A I = 42.06 A D. 3.5 mm² THW COPPER WIRE FOR POWER
3 4 Sxyz Triplex Pole Switch
2
USE : 2-8.0mm2 AND 1-5.5 mm GROUNDING THW IN 20 MM PVC 20 AT 20 AT S3w Three-Way Switch 8. ALL PANEL BOARD AND ENCLOSED AIR CIRCUIT BREAKER AND
NON-CURRENT CARRYING METAL PARTS OF ELECTRICAL EQUIPMENT
One 50 AT/50 AF, 2P 240V molded case circuit breaker Circuit Homerun Line
5 6 SHALL BE GROUNDED IN ACCORDANCE WITH PHILIPPINE
20 AT 20 AT ELECTRICAL CODE.
Switch Line
Power Circuit Line 9. ALL ELECTRICAL WORKS SHALL BE DONE UNDER THE DIRECT AND
IMMEDIATE SUPERVISION OF A DULY REGISTERED ELECTRICAL
ENGINEER.

CERTIFIED BY: PRC NO. : 0132486 SEAL : APPROVED BY: PROJECT TITLE: CAD BY: REVISIONS: SHEET NO.:
DESIGNED BY:
PTR NO. : 0418447
CHECKED BY:

CHARMAINE P. NARVADEZ
CIVIL ENGINEER
DATE :

PLACE :

T.I.N. :
01/08/19
NAGA CITY
453-268-413
MR & MRS. RODEL B. CORONO
OWNER
PROPOSED TWO-STOREY RESIDENTIAL BUILDING
LOCATION : ABELLA ST., STA.CRUZ, NAGA CITY
DATE:
APPROVED BY:
DATE:
SHEET CONTENTS:

AS SHOWN
E1