EGVV65A-FL-C3-4XR

8-port sector antenna, 2x 694–862, 2x 880–9 60 and 4x 1695–

2690 MHz, 65° HPBW, 4x RET. Low band arrays are diplexed at the
element level.
All Internal RET actuators are connected in “Cascaded SRET” configuration
Uses the 4.3-10 connector which is 40 percent smaller than the 7-16 DIN connector

General Specifications
Antenna Type Sector

Band Multiband

Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket

Performance Note Outdoor usage    |   Wind loading figures are validated by wind tunnel
measurements described in white paper WP-112534-EN

Radome Material Fiberglass, UV resistant

Radiator Material Aluminum    |   Low loss circuit board

Reflector Material Aluminum

RF Connector Interface 4.3-10 Female

RF Connector Location Bottom

RF Connector Quantity, high band 4

RF Connector Quantity, low band 4

RF Connector Quantity, total 8

Remote Electrical Tilt (RET) Information, General

RET Interface 8-pin DIN Female    |   8-pin DIN Male

RET Interface, quantity 1 female    |   1 male

Dimensions
Width 301 mm   |   11.85 in

Length 1,416.5 mm   |   55.768 in

Depth 180.5 mm   |   7.106 in

Array Layout
Page 1 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: April 30, 2020
EGVV65A-FL-C3-4XR

Electrical Specifications
Impedance 50 ohm

Operating Frequency Band 1695 – 2690 MHz    |   694 – 862 MHz    |   880 – 960 MHz

Polarization ±45°

Total Input Power, maximum 800 W @ 50 °C

Remote Electrical Tilt (RET) Information, Electrical

Protocol 3GPP/AISG 2.0 (Single RET)

Power Consumption, idle state, maximum 2W

Power Consumption, normal conditions, maximum 13 W

Input Voltage 10–30 Vdc

Internal RET High band (2)    |   Low band (2)

Page 2 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: April 30, 2020
EGVV65A-FL-C3-4XR
Electrical Specifications
Frequency Band, MHz 694–862 880–960 1695–1920 1920–2180 2300–2500 2500–2690
Gain, dBi 13.4 13.8 16.8 17.6 18 17.9
Beamwidth, Horizontal, 70 67 64 65 61 60
degrees
Beamwidth, Vertical, degrees 16.5 13.8 7.2 6.4 5.5 5.2
Beam Tilt, degrees 2–17 2–17 2–12 2–12 2–12 2–12
USLS (First Lobe), dB 16 16 19 18 17 17
Front-to-Back Ratio at 180°, 27 28 28 31 31 30
dB
Isolation, Cross Polarization, 28 28 28 28 28 28
dB
Isolation, Inter-band, dB 30 30 30 30 30 30
VSWR | Return loss, dB 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0

PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150 -150
Input Power per Port at 50° 200 200 250 250 250 200
C, maximum, watts

Electrical Specifications, BASTA

Frequency Band, MHz 694–862 880–960 1695–1920 1920–2180 2300–2500 2500–2690
Gain by all Beam Tilts, 13 13.5 16.3 17.3 17.7 17.6
average, dBi
Gain by all Beam Tilts ±0.4 ±0.4 ±0.8 ±0.5 ±0.5 ±0.5
Tolerance, dB
Gain by Beam Tilt, average, 2 ° | 12.7 2 ° | 13.1 2 ° | 16.3 2 ° | 17.1 2 ° | 17.7 2 ° | 17.5
dBi 10 ° | 13.1 10 ° | 13.7 7 ° | 16.5 7 ° | 17.4 7 ° | 17.9 7 ° | 17.8
17 ° | 12.9 17 ° | 13.4 12 ° | 16.1 12 ° | 17.0 12 ° | 17.2 12 ° | 17.2

Beamwidth, Horizontal ±2.1 ±3.5 ±5.6 ±6.2 ±5.2 ±4.6

Tolerance, degrees
Beamwidth, Vertical ±1.9 ±1 ±0.6 ±0.5 ±0.3 ±0.2
Tolerance, degrees
USLS, beampeak to 20° 19 16 11 14 12 12
above beampeak, dB
Front-to-Back Total Power at 22 21 21 24 25 22
180° ± 30°, dB
CPR at Boresight, dB 22 19 15 17 17 18
CPR at Sector, dB 10 11 9 11 8 9

Mechanical Specifications
Wind Loading at Velocity, frontal 206.0 N @ 150 km/h    |   46.3 lbf @ 150 km/h

Page 3 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: April 30, 2020
EGVV65A-FL-C3-4XR
Wind Loading at Velocity, lateral 170.0 N @ 150 km/h    |   38.2 lbf @ 150 km/h

Wind Loading at Velocity, maximum 397.0 N @ 150 km/h    |   89.2 lbf @ 150 km/h

Wind Speed, maximum 241 km/h   |   149.75 mph

Packaging and Weights

Width, packed 429 mm   |   16.89 in

Depth, packed 329 mm   |   12.953 in

Length, packed 1672 mm   |   65.827 in

Net Weight, without mounting kit 23.9 kg   |   52.69 lb

Weight, gross 35.9 kg   |   79.146 lb

Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
CHINA-ROHS Above maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant/Exempted

Included Products
BSAMNT- — Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members. Kit contains one scissor top
3 bracket set and one bottom bracket set.

* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance

Page 4 of 4

©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: April 30, 2020