Lecture 2

CE 433

Excerpts from Lecture notes of Professor M. Ashraf Ali, BUET.

 Water Pollution
 Surface Water Pollution
 Ground Water Pollution
 Types/Categories of Pollutants
 Nature of Origin

 Point Sources: Have well defined point of discharge

Types: i) Municipal point sources
ii) Industrial discharges

 Non-point Sources: Origin of discharge is diffuse; not

possible to relate discharge to a well defined location.
Types: i) Agriculture ii) Silviculture iii) Atmosphere iv) urban
and suburban runoff v) groundwater vi) drainage from
abandoned mines and construction activities, leaching from
land disposal and solid waste.
Point Source Loadings (in kg/day) in
Shitalakhya and Balu RIvers

Alam et al, 2011

 Types/Categories of Pollutants
 Group of Substances
 Oxygen demanding wastes
 Nutrients
 Pathogens
 Suspended solids
 Salts
 Toxic metals
 Toxic organic compounds
 Heat
 Radioactive substances
 Major Pollutant Categories and Principal sources
of Pollutants
Pollutant Category Point Sources Non-Point Sources

Domestic Industrial Agricultural Urban run

Sewage Waste runoff off
Oxygen-demanding X X X X
waste

Nutrients X X X X
Pathogens X X X X
Suspended X X X X
solids/sediments

Sayeed et al 2015
Salts X X X
Toxic metals X X
Toxic organic X X
chemicals
Heat X
 Oxygen Demanding Wastes
 Substances that oxidize in the receiving body of water
with the consumption of dissolved oxygen

Organic matter + O2 ------- CO2 + H2O + new cells +

stable product
 Oxygen Demanding Wastes
 Major Sources:
Biodegradable organic substances contained in
i) Municipal wastewater (mainly human waste and food
residue )
ii) Industrial wastewater (e.g. from tannery, textile, paper
& pulp and food processing industries)
 Minor Sources:
Crop residue, decaying plants and leaves, animal
droppings, oxidation at certain inorganic compounds
 Oxygen Demanding Wastes
 Measurement of strength of oxygen demanding wastes:
 BOD (Biochemical Oxygen Demand)
 COD (Chemical Oxygen Demand)
 Oxygen Demanding Waste
 Effects:
 Causes depletion of dissolved oxygen (DO) in water
 Saturation value of DO in water: 8-15 mg/L (depending on
temperature and salinity. Minimum DO required for
healthy fish population: 4-8 mg/L; 3 mg/L for certain
species
 If DO drops below the level necessary to sustain normal
life. Then the aquatic system is classified as “polluted”
 Oxygen demanding wastes also cause color, taste and
odor problem
 Pathogens
Disease-causing organisms that grow and multiply within
the host
 Source: Human and animal excreta
 Pathogens associated with water include:
 Bacteria: responsible for cholera, bacillary dysentery,
typhoid and paratyphoid fever
 Virus: responsible for hepatitis, poliomylitis, respiratory
and eye infections
 Protozoa: responsible for amoebic dysentery, giardiasis
 Helminths (parasitic worms): Hookworm, ascariasis
 Pathogens
 Classification of infections diseases associated with water:
 Waterborne disease: Oral ingestion of pathogens in water
contaminated by urine or feces
 Water-washed disease: Disease spread enhanced by scarcity
of water making cleanliness difficult
 Water-based disease: water provides the habitat for
intermediate host organisms, transmission to humans through
water contact
 Water-related disease: Insect vectors (e.g., mosquitoes) rely on
water to habitat, but human water contact not needed
Pathogen Indicators: - Total Coliform
- Faecal Coliform
- Thermotolerant coliform
- E coli
 Nutrients
 Chemicals that are essential for the growth of living
things (N, P, C, S, Ca, P, Fe, Mn, B, Ca, etc.)

 Nutrients are pollutants when their concentrations are

sufficient to allow excessive growth of aquatic plants,
particularly algae.

 The process of nutrient enrichment, leading to

excessive growth of algae, is called eutrophication
(algal bloom). This phenomenon is particularly
important for lakes
 Nutrients: Problems
 Algae eventually die and their decomposition removes
DO from water

 Algae and decaying organic matter add color, turbidity,

odor and objectionable taste to water, making it less
attractive as a source for domestic water supply,
recreational and other uses.

 Notice the greenish (sometimes reddish) color of pond,

lake, river water, especially during dry season
 Nutrients: Sources
 Major sources of nitrogen and
phosphorus include municipal
wastewater discharges municipal
wastewater discharges, runoff from
animal feedlots, chemical fertilizers
and phosphorus based detergents

 In addition, there are also natural

sources that may add nitrogen to the
water bodies. Certain bacteria and
blue-green algae can directly obtain
nitrogen from the atmosphere. These
life forms are abundant in lakes and
have high biological productivity.

 Certain form of acid rain can also

contribute nitrogen to the lakes.
 Suspended solids
 Organic or inorganic particles that are carried by the
wastewater into receiving waters are termed suspended
solids

 Many of these particles settle to the bottom of as sediment

 Colloidal particles that do not settle readily are the cause of
turbidity found in many surface waters

 Organic suspended solids may exert an oxygen demand

 Inorganic suspended solids are discharged by some
industries, result mostly from soil erosion
 Suspended solids
 Problems:
 An excessive sediment loads deposited into lakes and
reservoirs reduce their usefulness
 In rapidly flowing streams, sediments can disrupt
ecological habitats of many aquatic species
 For domestic water supply, excessive suspended solids
necessitate water treatment at an increases cost
 Salts
 Water naturally accumulates a variety of dissolved
solids and salts as it passes through soils and rocks.

 Certain industrial discharges also contain significant

dissolved salts (eg. Tannery effluent)

Typical cations: Na+, Ca2+, Mg2+, K+

Typical anions: Cl-, SO42-, HCO3-

Effects: Taste, odor

 Salts
 Commonly used measures of salinity:
 TDS (Total Dissolved Solids)
 Cl- (Chloride)
 Electrical Conductivity (EC)

 Freshwater: TDS <1500 mg/L

 Seawater: TDS ~ 30,000 – 34,000 mg/L
 Drinking water standard (Bangladesh): 1000 mg/L
 Agriculture: TDS upto 1500 mg/L can be tolerated by
most crops. Concentrations above 2100 mg/L generally
unsuitable for irrigation
 Thermal Pollution
 Impact of Climate change
 Primarily from industrial cooling water that is
discharged into river (typically from power plants)

 Adverse impacts:
 Sudden change in temperature can make it difficult for
local ecology to ever acclimate
 Adverse impact on dissolved oxygen
 Thermal Pollution
 Adverse impact of heat on dissolved oxygen
 As temperature increases, metabolic rate of aquatic life
increases – usually by a factor of 2 for each 10degreesC
rise in temperature. As a result, oxygen demand of
aquatic organisms increases
 As temperature increases, waste assimilation capacity
becomes quicker (ie, bacteria decomposes organic matter
at a faster rate), drawing down dissolved oxygen at a
faster rate
 As temperature increases, O2 holding capacity of water
goes down -> O2 demand goes up and O2 availability
goes down. As a result O2 level in water goes down
quickly and water quality becomes worse
 Example: River water quality
 Heavy Metals
 Usually it simply denotes metals that are toxic. Toxic
metals include: Al, As, Be, Bi, Cd. Cn, Co, Mn, Hg, Pb,
Se etc.

 Adverse Impacts:
 Nervous system and kidney damage – creation of mutation
and induction of tumor
 Source: Industrial discharges, natural (eg. As in
groundwater of Bangladesh)
 Often referred to as “Persistent” (inorganic) pollutant (ie,
remain in the environment for long without degradation)
 Heavy metals of concern in Bangladesh groundwater:
- As and Mn
 Pesticides
 Chemicals that kill undesirable organisms:
 Categories:
 Insecticides – most widely used
 Herbicides – destroy plants, weeds, etc.
 Rodenticides – kill rats, mice, etc.
 Fungicides – kill fungi or their spores

 The main groups of synthetic organic insecticides include:

 Organochlorine (chlorinated hydrocarbons)
 Organophosphates
 Carbamates
 Pesticides
 Organochlorines:
 e.g., DDT, aldrin, endrin, heptachlor, methoxychlor
 Often referred to as “persistent organic compound” (POC)
 Accumulates in lipid or fat cells

 Effects: Liver cancer, birth defects

 Not widely used now. Has been replaced by
organophosphates and carbamates.
 Pesticides
 Organophosphates:
 e.g. Parathion, diazinon, tetraethyl phosphate
 Not very persistent
 Effects: Tremor, confusion, muscle twitching, convulsions

 Carbamates:
 e.g. aldicurb, carboxyl
 Effects: nausea, vomiting, blurred vision, convulsions
 Volatile Organic Compounds
(VOC)
 Often used as solvents in industrial processes
 Most commonly found contaminant in groundwater
 “Persistent Organic Compound” (POC)
 5 VOCs are specially toxic and persistent and their
presence in drinking water is a cause of special concern.
These are:
 Vinyl Chloride: human carcinogen
 Tetrachloroethylene: suspected carcinogen
 Trichloroehtylene: suspected carcinogen
 1,2 – Dichloroethane: causes injury to central nervous
system, liver and kidneys
 Carbon Tetrachloride: Very toxic if ingested. A few mL can
cause death
 Persistent Organic Pollutants
(POPs)
 Organic substances that:
 possess toxic characteristics;
 are persistent;
 Bioaccumulate;
 are prone to long-range trans-boundary atmospheric
transport and deposition;
 are likely to cause significant adverse human health or
environmental effects near to and distant from their
sources
 Persistent Organic Pollutants
(POPs)
 Government of Bangladesh has signed the Stockholm
Convention on POP on 23 May 2001. As a Party and
signatory to the Convention, Bangladesh is required to
take actions to generate general awareness of harmful
consequences of POPs, to reduce their releases, and
their ultimate elimination.

 The Stockholm Convention identifies 12 substances as

POPs, which include:
 9 substances used as pesticides
 Polychlorinated biphenyl (PCBs), and
 Dioxins and Furans
 Persistent Organic Pollutants
(POPs)
 POPs Pesticides
 There are 9 pesticides namely Aldrin, Chlordane, Dieldrin,
Endrin, Heptachlor, Mirex, Toxaphone, DDT and
Hexachlorobenzene
 Persistent Organic Pollutants
(POPs)
 POPs – Polychlorinated biphenyl (PCBs)
 PCBs are chlorinated hydrocarbons that have been
widely used as industrial chemicals since 1930. There are
209 varieties of PCBs. Large quantities of PCBs were
produced for use as a cooling and dielectric fluid in
electric transformers and in large capacitors.
 PCBs are linked to reproductive failure and suppression
of the immune system in various wild animals, severe
human intoxication occurred due to accidental
consumption of PCB-containing oils.
 IARC (International Agency for Research on Cancer)
classified PCB into Group 2B (possibly carcinogenic to
human). International production of PCBs was ended in
most countries by 1980
 Video
 https://www.youtube.com/watch?v=RMyCcWECbNE