Scribd
Upload
1K views2 pages

FD-CON-2: Fire Damper Control Unit

The document provides information about the FD-CON-2 fire damper control unit. The FD-CON-2 unit can be used to control Halton fire dampers locally from both sides of a bulkhead or deck, as required by SOLAS regulations. It has features like IP67 protection, LED lights to indicate damper position, and can be used for either electrically or pneumatically operated dampers. Diagrams show the unit can be set up as a single controller or as a master/slave configuration to control dampers from multiple locations.

Uploaded by

kevin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views2 pages

FD-CON-2: Fire Damper Control Unit

The document provides information about the FD-CON-2 fire damper control unit. The FD-CON-2 unit can be used to control Halton fire dampers locally from both sides of a bulkhead or deck, as required by SOLAS regulations. It has features like IP67 protection, LED lights to indicate damper position, and can be used for either electrically or pneumatically operated dampers. Diagrams show the unit can be set up as a single controller or as a master/slave configuration to control dampers from multiple locations.

Uploaded by

kevin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

FIRE DAMPER CONTROL UNIT • FD-CON-2

FD-CON-2 FIRE DAMPER CONTROL UNIT


For Halton Marine fire dampers

APPLICATIONS
The FD-CON-2 fire damper switch is a control unit for
Halton fire dampers. The control unit is installed near the
damper in a place where personnel has easy and logical
access to it. Two or more FD-CON-2 units can be
connected in series. This allows the damper to be locally
controlled from both sides of the bulkhead or deck as per
SOLAS regulation.
The FD-CON-2 is mainly intended for electrically operated
dampers, but it can also be used for pneumatic dampers.
In this case the FD-CON-2 unit controls the solenoid valve
that controls the supply air to the damper actuator.

FEATURES
• Single or multiple controllers per damper with easy
jumper based master/slave configuration

• Protection marking IP67

• Polycarbonate box with M20 cable glands (M25 on


request)

• M20 cable gland, cable diameter Ø 7-13 mm

• M25 cable gland, cable diameter Ø 10-17 mm

• CE certified product

• Operating range: 18 - 28 VDC 1A, 18 - 253 VAC 50/60Hz


125 mA

• LED lights indicate the damper open and closed


positions

• Test switch for indication LED lights

1
FIRE DAMPER CONTROL UNIT • FD-CON-2

GENERAL FD-CON-2 DRAWINGS

All glands M20 or M25

Mounting holes 4 x 4,5 mm


M01Y2019/Halton Marine reserves the right to alter products without notice.

CONTROLLER SETUP, ELECTRICAL DAMPERS

18-253 VAC/VDC

FD-CON-2 MASTER 18-253 VAC/VDC FD-CON-2 SLAVE FD-CON-2 MASTER

Single controller Master / Slave controllers

You might also like