Scribd
Upload
22 views9 pages

Isotropic Plate With Hole

This document provides instructions for simulating an isotropic plate with a hole using finite element analysis software. It describes setting up the model geometry with dimensions of 0.75 x 0.25 for the plate and a hole radius of 0.1, defining the material, meshing the assembly as a dependent instance, applying appropriate boundary conditions and loads, and obtaining results from the simulation.

Uploaded by

Oscar Sotomayor
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
22 views9 pages

Isotropic Plate With Hole

This document provides instructions for simulating an isotropic plate with a hole using finite element analysis software. It describes setting up the model geometry with dimensions of 0.75 x 0.25 for the plate and a hole radius of 0.1, defining the material, meshing the assembly as a dependent instance, applying appropriate boundary conditions and loads, and obtaining results from the simulation.

Uploaded by

Oscar Sotomayor
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 9

Simulation of a Isotropic plate with a hole

Date: 03-07-2019

Based on video:

https://www.youtube.com/watch?v=TCtfle5vaH8

TUTORIAL

PART
0.75 x 0.25 radio of hole 0.1

MATERIAL
SECTION

ASSEMBLY

Dependent Instance

STEP
SETS

Left
SETS
Botton

SURFACES
BOUNDARY CONDITIONS
LOADS
RESULTS

You might also like