Scribd
Upload
2K views1 page

Lifting Trunnion Analysis

This document analyzes the stresses on a lifting trunnion with an applied load of 1,348,875 N including a shock factor of 1.2, resulting in a load of 1,616,850 N. It provides the material properties and dimensions of the trunnion made of SA 106 Gr B steel. Calculations show the bending stress of 104.28 N/mm^2 and shear stress of 69.55 N/mm^2 are below the allowable limits, so the trunnion design is deemed safe under the given loading. A full penetration weld is used to attach the trunnion to the plate.

Uploaded by

prajwal86
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views1 page

Lifting Trunnion Analysis

This document analyzes the stresses on a lifting trunnion with an applied load of 1,348,875 N including a shock factor of 1.2, resulting in a load of 1,616,850 N. It provides the material properties and dimensions of the trunnion made of SA 106 Gr B steel. Calculations show the bending stress of 104.28 N/mm^2 and shear stress of 69.55 N/mm^2 are below the allowable limits, so the trunnion design is deemed safe under the given loading. A full penetration weld is used to attach the trunnion to the plate.

Uploaded by

prajwal86
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

JOB NO.

: 0
ITEM NO. : 0
LIFTING TRUNNION ANALYSIS

LOAD PER TRUNNION N 1348875


SHOCK FACTOR, F 1.2
LOAD PER TRUNNION N 1618650

MATERIAL: SA 106 Gr B
YIELD STRESS, Ys N/mm^2 217.211
ALLOWABLE STRESS BENDING SHEAR
0.66Ys 0.33Ys
N/mm^2 143.36 71.67963
DIMENSIONS :

ID OF TRUNNION mm 325.42
THK OF TRUNNION mm 40.49
OD OF TRUNNION mm 406.4
EFFECTIVE CROSS SECTION AREA mm^2 23272
SECTION MODULUS mm^3 3.881E+06

STRESSES IN TRUNNION :

BENDING STRESS IN TRUNNION


MOMENT ARM mm 250
BENDING MOMENT N-mm 404662500
BENDING STRESS N/mm^2 104.28 HENCE SAFE

SHEAR STRESS IN TRUNNION N/mm^2 69.55 HENCE SAFE

FULL PENETRATION WELDING PROVIDED FOR TRUNNION TO PLATE WELD.

You might also like