Scribd
Upload
101 views1 page

Federal Standard FS.595a/595B To Model Paints: View This Colour

The Federal Standard FS.595a/595B establishes a coding system for model paint colors using a five-digit numbering system. The first digit indicates the level of sheen from gloss to matte. The second digit classifies the general color group from brown to other colors like white or metallic. The last three digits indicate the color intensity from dark to light. While the standard provides color chips for specific codes, it does not define colors for all possible combinations, so closest matches must sometimes be used instead of exact colors.

Uploaded by

Chris Bradley
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
101 views1 page

Federal Standard FS.595a/595B To Model Paints: View This Colour

The Federal Standard FS.595a/595B establishes a coding system for model paint colors using a five-digit numbering system. The first digit indicates the level of sheen from gloss to matte. The second digit classifies the general color group from brown to other colors like white or metallic. The last three digits indicate the color intensity from dark to light. While the standard provides color chips for specific codes, it does not define colors for all possible combinations, so closest matches must sometimes be used instead of exact colors.

Uploaded by

Chris Bradley
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Federal Standard FS.

595a/595B to model paints

The colours in the Federal Standard set have no official names, just five-digit numbers. Any names given below are generic. The example of the FS number could be:
  Example 

35526
View this colour 

The first figure can be 1,2 or 3 and indicates the level of sheen:
 1 = gloss
 2 = semigloss
 3 = matt
For simplicity, all colours in this chart are referred to as matt (begin with 3). colour matches for matt colours apply also to semi-gloss or gloss colours - just replace the
leading digit with 2 or 1, respectively.
Matt, satin or gloss clear lacquer should be applied to painted object to obtain the desired quality of finish.
The second figure of FS code indicates a general colour classification group -
 0 = brown
 1 = red
 2 = orange
 3 = yellow
 4 = green
 5 = blue
 6 = grey
 7 = other (white, black, violet, metallic)
 8 = fluorescent
The remaining figures (third to fifth) combined into a number indicate the intensity. Lower value indicates a darker colour, higher value - a lighter colour, with no other
significance. The numbers have been assigned with gaps to allow addition of new colours.
FS.595 is a colour collection, not a complete colour system, and this has the following implications:
 The existence of a colour chip 3xxxx in the FS binder does not imply that there is a colour chip for 1xxxx. However, references to such "virtual" chips built on the
principle "same colour, but different sheen" is a widespread practice in model-related literature.
  
 The FS in not extensible, i.e. it does not allow to derive new colours form the existing ones. Thus, if you compare i.e. RLM colours to FS codes, you can only refer to
the nearest existing FS colour, which most often is not a perfect match. In practice, the FS set is extensive enough to find a good-enough match for almost any colour.
This chart has been last revised in September 2006 

You might also like