Assessment System: Take Assessment - Module 6 Exam - CCNA 1 Networking Basics (Version 3.1)
Assessment System: Take Assessment - Module 6 Exam - CCNA 1 Networking Basics (Version 3.1)
Refer to the exhibit. Host A is communicating with host F. What happens to a frame sent from
to host F as it travels over the Ethernet segments?
The frame format is modified as it passes through each switch.
The frame format remains the same across each Ethernet segment.
The frame format is modified as the media speed changed at switch B and switch E.
The frame format is modified as the media material changes between copper and fiber at s
and switch D.
Refer to the exhibit. All hosts are in listen mode. Host 1 and Host 4 both transmit data at the sa
time. How do the hosts respond on the network? (Choose two.)
Hosts 1 and 4 may be operating full duplex so no collision will exist.
The hub will block the port connected to Host 4 to prevent a collision.
After the end of the jam signal, Hosts 1, 2, 3, and 4 invoke a backoff algorithm.
When the four hosts detect the collision, Hosts 1, 2, 3, and 4 generate a jam signal.
Hosts 1 and 4 are assigned shorter backoff values to provide them priority to access the m
If a host has data to transmit after the backoff period of that host, the host checks to determ
the line is idle, before transmitting.
4At what layer of the OSI model does a MAC address reside?
1
2
3
4
7
5 A router has an Ethernet, Token Ring, serial, and ISDN interface. Which interfaces will have a
address?
serial and ISDN interfaces
Ethernet and Token Ring interfaces
Ethernet and ISDN interfaces
Token Ring and serial interfaces
Refer to the exhibit. A technician wants to increase the available bandwidth for the workstation
allowing the switch and the NIC on the workstation to transmit and receive simultaneously. Wh
permit this?
CSMA/CD
full-duplex
FastEthernet
crossover cable
Refer to the exhibit. The small office network shown in the exhibit consists of four computers
connected through a hub. Which configuration would cause collisions and errors on the netwo
autonegotiation
FastEthernet
peer-to-peer shared resources
administratively configured full duplex
8When a collision occurs in a network using CSMA/CD, how do hosts with data to transmit resp
after the backoff period has expired?
The hosts return to a listen-before-transmit mode.
The hosts creating the collision have priority to send data.
The hosts creating the collision retransmit the last 16 frames.
The hosts extend their delay period to allow for rapid transmission.
9 In an Ethernet LAN, how does the NIC know when it can transmit data?
An Ethernet NIC transmits data as soon as the frame is received.
An Ethernet NIC transmits data as soon as the NIC receives a token.
An Ethernet NIC transmits data when it senses a collision.
An Ethernet NIC transmits data after listening for the absence of a signal on the media.
Which two devices can provide full-duplex Ethernet connections? (Choose two.)
10 hub
modem
repeater
NIC
Layer 2 switch
Which statement describes how CSMA/CD on an Ethernet segment manages the retransmis
12 frames after a collision occurs?
The first device to detect the collision has the priority for retransmission.
The device with the lowest MAC address determines the retransmission priority.
The devices on the network segment hold an election for priority to retransmit data
The devices transmitting when the collision occurs DO NOT have priority for retransmissi
13 In which two layers of the OSI model does Ethernet function? (Choose two.)
application
session
transport
network
data link
physical
Which of the following are specified by IEEE standards as sublayers of the OSI data link laye
14 (Choose two.)
Logical Link Control
Logical Layer Control
Media Access Control
Logical Link Communication
Media Access Communication
Physical Access Communication
15
Refer to the exhibit. The switch and workstation are administratively configured for full-duplex
operation. Which statement accurately reflects the operation of this link?
No collisions will occur on this link.
Only one of the devices can transmit at a time.
The switch will have priority for transmitting data.
The devices will default back to half duplex if excessive collisions occur.
All content copyright 1992-2005 Cisco Systems, Inc. Privacy Statement and Trademarks
Which characteristics describe carrier sense multiple access collision detect (CSMA/CD)? (C
19 three.)
reliable
point-to-point
nondeterministic
connection-oriented
collision environment
first-come, first-served approach
All content copyright 1992-2005 Cisco Systems, Inc. Privacy Statement and Trademarks