TM

MASTER GRIPPERS
TECHNICAL DATA
#12-11 MASTER GRIPPER DIAPHRAM #14-10 MASTER GRIPPER
DIMENSIONAL PROPERTIES DIMENSIONAL PROPERTIES

A A
A Head Across Flats .244” - .250”
D
B Major Diameter .215” - .221” A Head Across Flats .367” - .375”
B B
C Minor Diameter .155” - .162” B Major Diameter .248” - .254”

Stress Area .01255 in.2 C Minor Diameter .178” - .185”

C C
D Shoulder Diameter 1/4”
Stress Area .01781 in.2
Shoulder Length 1/4”

STANDARD MECHANICAL REQUIREMENTS STANDARD MECHANICAL REQUIREMENTS

FOR LELAND AVERAGE VALUES SEE PAGE 23 FOR LELAND AVERAGE VALUES SEE PAGE 23
Minimum Tensile Strength 3500 lbs. Minimum Tensile Strength 4300 lbs.
Minimum Torsional Strength 90 in.-lbs. Minimum Torsional Strength 156 in.-lbs.
Minimum Shear Strength 2100 lbs. Minimum Shear Strength 2580 lbs.

PULL-OVER STRENGTH PULL-OVER STRENGTH

18 .050” 18 .050”
12mm 15mm
NOM. 1/2” .040” NOM. 5/8” .040”
MASTER 20 MASTER 20 •
SEAL 22 .030” SEAL 22 • .030”
BONDED 24 • EPDM 24 •
WASHER 26 • .020” WASHER 26 .020”

.010” .010”
1000

1200

1400

1600

1800

2000

2200

2400
1000

1200

1400

1600

1800

2000

2200

2400

400

600

800
#
400

600

800
#

REFER TO PAGE 8 FOR PULL-OUT STRENGTH TECHNICAL DATA

SHEAR STRENGTH - SEE INSIDE BACK COVER

HEAVY DUTY MASTER GRIPPERS - UNASSEMBLED

#18-9 x 1-5/8” & 2-1/2” MASTER GRIPPER #24-9 x 1” & 2” MASTER GRIPPER
DIMENSIONAL PROPERTIES DIMENSIONAL PROPERTIES

A A Head Across Flats .305” - .312” A A Head Across Flats .367” - .375”

B B Major Diameter .300” - .306” B B Major Diameter .383” - .389”

C Minor Diameter .209” - .217” C Minor Diameter .282” - .291”

C Stress Area .03071 in.2 C Stress Area .06190 in.2

STANDARD MECHANICAL REQUIREMENTS STANDARD MECHANICAL REQUIREMENTS

FOR LELAND AVERAGE VALUES SEE PAGE 23 FOR LELAND AVERAGE VALUES SEE PAGE 23
Minimum Tensile Strength 4550 lbs. Minimum Tensile Strength 10766 lbs.
Minimum Torsional Strength 250 in.-lbs. Minimum Torsional Strength 640 in.-lbs.
Minimum Shear Strength 2570 lbs. Minimum Shear Strength 6460 lbs.
Master Seal is a registered trademark of Aztec Washer Company, Inc.
All test results and suggestions are based on laboratory tests. Specific job site conditions should be taken into consideration
when specifying the proper fasteners. Because applications vary, we assume no liability for use of this information.

4 MASTER GRIPPERS 2008