Scribd
Upload
32 views4 pages

Read My

The document provides steps for rewriting a program from a CD to a hard disk or stick using a programmer. It outlines connecting the programmer, downloading the program, selecting the chip type, reading and writing to the chip, and changing the CRUM field numbers before writing the new program to the chip.

Uploaded by

Guto Gtturbo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
32 views4 pages

Read My

The document provides steps for rewriting a program from a CD to a hard disk or stick using a programmer. It outlines connecting the programmer, downloading the program, selecting the chip type, reading and writing to the chip, and changing the CRUM field numbers before writing the new program to the chip.

Uploaded by

Guto Gtturbo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 4

Rewrite the program from the CD to the hard disk (or stick)

Modus Operandi c programmer.

1. Connect the programmer to the computer. Connect COM and USB


computer ports to the corresponding inputs of the programmer. LED
glows green.

2. Download the program.

2.1 Confi-> Setup-> Port Setup


2.2 Pick a port is connected to the programmer

2.3 Confi->Setup->Resetter Test


2.4 Test ok

2.5 If not OK options

2.5.1 Offline Programmer


2.5.2 The Programmer is connected to another port
2.5.3 defective port
2.5.4 defective connecting cable.
2.5.5 defective programmer.

3. Connect adapter to the programmer.


4. Choose the type of chip (Chip Models)

5. Connect the chip.

6. Read the chip. (Read chip) (red LED lights)

6.1. If the chip is not read

6.1.1 Authentication failed. I choose the wrong group of devices. No


need to try again. (only 8 attempts) should immediately verify that
the selected device to coincide with the chip.
6.1.2 Authentication failed. The device is correct. Read the
configuration. Read CFG. Then work with the chip.
6.1.2 Authentication failed. Bad contact with the chip. (extremely
rare)
6.1.2 Occupied tire, or some other error - a bad contact with the
chip. Spring-loaded contacts easy thing, but they have to adjust.
Crocodiles - reliably, but inconvenient.

7. Download file (open file) c firmware appropriate type of


apparatus.

8. Find CRUM field and change the marked area on the unit. Changing
the number, please note - in these cells must be only numbers. We are
changing the last three. We reach the thousands and start again.

9. Record chip (write chip) (red LED lights)

10. If you want to flash another cartridge, proceed to step 7,


otherwise - write a file (write file) and close the program.

You might also like