Scribd
Upload
59 views6 pages

TMS320C6416 DSP Starter Kit: Designed By: Dawar Awan

This document summarizes the specifications and programming of a TMS320C6416 DSP Starter kit designed by Dawar Awan from Oct 2012 to Feb 2013. The starter kit contains a 1GHz TMS320C6416 DSP, 16MB of DRAM, 512KB of flash memory, an AIC23 stereo codec, 4 LEDs and DIP switches. It can be programmed using TI's Code Composer Studio or LabVIEW. Two tasks are described: 1) assigning different tones to DIP switches, and 2) acquiring audio with noise added depending on the switched DIP switch.

Uploaded by

Umer Ehsan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views6 pages

TMS320C6416 DSP Starter Kit: Designed By: Dawar Awan

This document summarizes the specifications and programming of a TMS320C6416 DSP Starter kit designed by Dawar Awan from Oct 2012 to Feb 2013. The starter kit contains a 1GHz TMS320C6416 DSP, 16MB of DRAM, 512KB of flash memory, an AIC23 stereo codec, 4 LEDs and DIP switches. It can be programmed using TI's Code Composer Studio or LabVIEW. Two tasks are described: 1) assigning different tones to DIP switches, and 2) acquiring audio with noise added depending on the switched DIP switch.

Uploaded by

Umer Ehsan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

Lab No.

09

TMS320C6416 DSP Starter kit

Designed by : Dawar Awan


Oct 2012 – Feb 2013
CECOS College of Engineering and IT [email protected]
Specifications
 A Texas Instruments TMS320C6416 DSP operating at 1GHz
 Delivering up to 8000 MIPS
 An AIC23 stereo codec
 16 Mbytes of synchronous DRAM
 512 Kbytes of non-volatile Flash memory
 4 user accessible LEDs and DIP switches
 Configurable boot options
 Standard expansion connectors for daughter card use
 Single voltage power supply (+5V)

CECOS College of Engineering and IT [email protected]


Hardware features

CECOS College of Engineering and IT [email protected]


Programming TMS320C6416 DSK
 TI’s Code Composer Studio (CCS) is primarily used to program the
TMS320C6416 DSK

 Other than CCS, MatLab/Simulink and LabVIEW can also be used


to program this DSK

CECOS College of Engineering and IT [email protected]


Programming TMS320C6416 DSK using LabVIEW
 The method/steps are the same as those for SPEEDY33
 Only DSK6416 should be selected as the target type, this time

CECOS College of Engineering and IT [email protected]


Task
1. Program the DSK so that by turning on a DIP switch a tone could
be heard, assign four different frequencies to the four DIP
switches.
2. Program the DSK so that an audio signal can be acquired and
heard at the same time but if a DIP switch is turned ON, a noise
should be added to the audio. Assign four different noise patterns
to the four DIP switches.

CECOS College of Engineering and IT [email protected]

You might also like