Stainless Steel Swing Check Valve: Threaded Connection - 200 WOG
Stainless Steel Swing Check Valve: Threaded Connection - 200 WOG
B 4
1
T-550
6
Features
• Manufactured in ISO-9001 facility
7
• Heavy pattern body
• One-piece body design
• PTFE o-ring seal
• Metal to metal disc seal
Approvals
• ANSI B1.20.1 C
Pressure/Temperature Rating
• 200 WOG Material Specifications
No. Part Materials
• -4°F to 392°F
1 Body ASTM A351-CF8M
Install 5 pipe diameter minimum downstream from pump 2 Cap ASTM A351-CF8M
discharge or changes in direction to avoid flow 3 Seal PTFE
turbulence. Flow straighteners may be required in 4 Plug AISI 316
extreme cases. 5 Disc ASTM A351-CF8M
6 Gasket PTFE
Note: On pump discharge, the preferred check valves are: 7 Bolt AISI 304
inline, spring assisted, center-guided, lift checks.
Dimensions
Jomar Check Valves may be installed in both horizontal Part No. Size A B C
and vertical lines with upward flow or in an intermediate 105-803 1/2" 2.56 1.73 1.83
position. They will operate satisfactory in a declining plane 105-804 3/4" 3.15 2.05 2.05
(no more than 15° ). 105-805 1" 3.50 2.44 2.20
105-806 1-1/4" 4.13 2.64 2.56
Warning: Do Not Use For Reciprocating Air Compressor 105-807 1-1/2" 4.72 3.11 2.95
Service 105-808 2" 5.47 3.15 3.31
WARNING: This product can expose you to chemicals including nickel, which is known
! to the State of California to cause cancer. For more information go to
www.P65Warnings.ca.gov.
Note: Information subject to change without notice. 082918 © 2018 Jomar Valve • www.jomarvalve.com • P: (586) 268-1220 • F: (586) 979-8315