Cotter Joint
Cotter Joint
Cotter Joint
A cotter is a flat wedge shaped piece of rectangular cross-section and its wi dth is tapered
(either on one side or both sides) from one end to another for an easy adjustm ent. The taper
varies from 1 in 48 to 1 in 24 and it may be increased up to 1 in 8, if a lock ing device is
provided. The locking device may be a taper pin or a set screw used on the low er end of the
cotter. The cotter is usually made of mild steel or wrought iron. A cotter joint is a temporary
fastening and is used to connect rigidly two co-axial rods or bars which are subjjected to axial
tensile or compressive forces. It is usually used in connecting a piston rod to the crosshead
of a reciprocating steam engine, a piston rod and its extension as a tail or pump rod , strap
end of connecting rod etc.
Types of Cotter Joints
Following are the three commonly used cotter joints to connect two rods by a cotter:
1. Socket and spigot cotter joint, 2. Sleeve and cotter joint, and 3. Gib and cotter joint.
Socket and Spigot Cotter Joint
In a socket and spigot cotter joinnt, one end of the rods (say A) is provided with a socket type
of end as shown in Fig., and the other end of the other rod (say B) is inserted into a socket.
The end of the rod which goes into a socket is also called spigot. A rectangular hole is made
in the socket and spigot. A cotteer is then driven tightly through a hole in order to make the
temporary connection between the two rods. The load is usually acting axially, but it changes
its direction and hence the cotter joint must be designed to carry both the tensile and
compressive loads. The compressive load is taken up by the collar on the spigot.
t = Thickness of cotter,
l = Length of cotter,
a = Distance from the en d of the slot to the end of rod,
σt = Permissible tensile stress for the rods material,
τ = Permissible shear stress for the cotter material, and
σc = Permissible crushing stress for the cotter material.
The dimensions for a socket and spigot cotter joint may be obtained by considering the
various modes of failure as discussed below:
1. Failure of the rods in tension
From this equation, the diameeter of spigot or inside diameter of socket (d 2) may be
determined. In actual practice, the thickness of cotter is usually taken as d 2 / 4.
3. Failure of the rod or cotter in crushing
From this equation, the induced crushing stress may be checked.
4. Failure of the socket in tension across the slot
From this equation, the thicknesss of socket collar (c) may be obtained.
8. Failure of rod end in shear
From this equation, the distancee from the end of the slot to the end of the rod (a) may be
obtained.
9. Failure of spigot collar in crushing
From this equation, the diameter of the spigot collar (d 3) may be obtained.
10. Failure of the spigot collar in shearing