Scribd
Upload
1K views3 pages

Certified Solidworks Associate (Cswa) : Sample Exam Questions

The document provides 3 sample exam questions for the Certified SolidWorks Associate (CSWA) certification. Question 1 asks to build a part model in SolidWorks and calculate its mass. Question 2 asks which statement about COSMOSXpress mesh settings is not true. Question 3 asks which type of SolidWorks view is necessary to create drawing view B, which requires sketching a spline on drawing view A. The questions are designed to test modeling, analysis, and drawing skills and be completed within specific time limits.

Uploaded by

Meme Boh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
1K views3 pages

Certified Solidworks Associate (Cswa) : Sample Exam Questions

The document provides 3 sample exam questions for the Certified SolidWorks Associate (CSWA) certification. Question 1 asks to build a part model in SolidWorks and calculate its mass. Question 2 asks which statement about COSMOSXpress mesh settings is not true. Question 3 asks which type of SolidWorks view is necessary to create drawing view B, which requires sketching a spline on drawing view A. The questions are designed to test modeling, analysis, and drawing skills and be completed within specific time limits.

Uploaded by

Meme Boh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

CSWA Sample Exam Questions

Certified SolidWorks Associate (CSWA)


Sample Exam Questions
The questions below represent sample CSWA Exam questions. Part modeling and
assembly modeling questions that require you to build model should be correctly
answered in 45 minutes or less. Question 2 and Question 3 should be correctly
answered in 5 minutes or less.

Question 1.
Build this part in SolidWorks.
Unit system: MMGS (millimeter, gram, second)
Decimal places: 2. Part origin: Arbitrary
A = 63mm, B = 50mm, C = 100mm. All holes through
all. Part material: Copper Density = 0.0089 g/mm^3
What is the
overall mass of
the part in Z0
grams?
40
a) 1205

b) 1280
18
c) 144

d) 1108
R10

3]
40’

PAGE 1'
Question 2.
COSMOSXPress allows changes to mesh settings. Which of the following
statements is not True?

a) A fine mesh setting produces more accurate results than a course mesh.
b) A coarse mesh setting produces less accurate results than a fine mesh.
c) A fine mesh setting can be applied to a specific face instead of the entire
model.
d) All of the above

Question 3.
To create drawing
view, ‘B’ it is necessary
to sketch a spline (as
shown) on drawing
view ‘A’ and insert
which SolidWorks view
type?

a) Brokenout Section

b) Aligned Section

c) Section

d) Detail

PAGE 2”
Thank you for using www.freepdfconvert.com service!

Only two pages are converted. Please Sign Up to convert all pages.

https://www.freepdfconvert.com/membership

You might also like