Scribd
Upload
48 views1 page

Bush

The document outlines a 7 step process for turning an MS bright bar on a lathe machine. The process includes facing, turning, reversing, step turning, center drilling, drilling, and tapping operations to produce a part with an outer diameter of 16.6mm, inner diameter of 8mm, and total length of 20mm including a 5mm long collar section of 19mm diameter. Speed and feed rates are listed for each tool.

Uploaded by

Pooja Ban
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
48 views1 page

Bush

The document outlines a 7 step process for turning an MS bright bar on a lathe machine. The process includes facing, turning, reversing, step turning, center drilling, drilling, and tapping operations to produce a part with an outer diameter of 16.6mm, inner diameter of 8mm, and total length of 20mm including a 5mm long collar section of 19mm diameter. Speed and feed rates are listed for each tool.

Uploaded by

Pooja Ban
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Sr.

no Process Tool Speed/Feed


1. Facing Facing tool 1120rpm/Hand Feed
2. Turning, D=19, L=5 Turning Tool 1120rpm/Hand Feed
3. Reverse the side of workpiece
4. Facing, L=20 ,(4 nos. of cut) Facing tool 1120rpm/Hand Feed
5. Step Turning, D =16.6, L=20 (4 nos. Turning tool 1120rpm/Hand Feed
of cut)
6. Center drilling Center drill 1120rpm/Hand Feed
7. Drilling D=6.7 HSS Drill D=6.7 710rpm/Hand Feed
(Tool held in
tailstock with drill
chuck)
Tapping Tap set M8, Hand Feed
Tap Wrench
LATHE MACHINE

Raw material – MS Bright bar (D=20 mm)


OD=16.6mm
ID=8mm
Total length= 20mm
Collar ( OD=19mm, length =5mm) .

(Note= all dimensions are in mm)

You might also like