Scribd
Upload
40 views1 page

Front

The document outlines a 10 step machining process for an aluminum alloy workpiece using a lathe machine, including facing, turning, drilling holes of various diameters, boring, internal threading, and tapping steps, along with the tools and speeds used for each step. The raw material and final dimensions of the workpiece are also specified.

Uploaded by

Pooja Ban
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
40 views1 page

Front

The document outlines a 10 step machining process for an aluminum alloy workpiece using a lathe machine, including facing, turning, drilling holes of various diameters, boring, internal threading, and tapping steps, along with the tools and speeds used for each step. The raw material and final dimensions of the workpiece are also specified.

Uploaded by

Pooja Ban
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Sr.

no Process Tool Speed/Feed


1. Facing Facing tool 1120rpm/Hand Feed
2. Turning Turning Tool 1120rpm/Hand Feed
3. Reverse the side of workpiece
4. Facing, L=10,(4 nos. of cut) Facing tool 1120rpm/Hand Feed
5. Turning, D =60, L=10(4 nos. of cut) Turning tool 1120rpm/Hand Feed
6. Center drilling Center drill 1120rpm/Hand Feed
7. Drilling D=10 HSS Drill D=10 71rpm/Hand Feed
(Tool held in
tailstock with drill
chuck)
8. Drilling D=20 HSS Drill D=15 71rpm/Hand Feed

9. Drilling D=25 HSS Drill D=20 71rpm/Hand Feed

10. Boring D=34,(from both ends L=8) Boring tool 1120rpm/Hand feed

Internal Threading D=35 (24TPI) Threading tool 1120rpm/Hand feed

Drilling (D=4.2) Drilling tool 750rpm/Hand feed


Vertical drilling
machine
Taping M5,PCD=48,no=6, Tapping tool Hand feed

LATHE MACHINE

Raw material – Aluminium alloy 6061 (D=65mm, L=15mm)


OD=60mm
ID=35mm
Total length= 10mm
Internal thread
ID=35, (24 TPI)
Tapping
PCD= 48, M5, (24 TPI)
(Note= all dimensions are in mm)

You might also like