Kappalite 3015 LF

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

Specification

Nominal Basket Diameter 15”, 381mm


Nominal Impedance* 8 ohms
Power Rating**
Watts 450W
Music Program 900W The Art and Science of Sound
Resonance 42Hz
Usable Frequency Range*** 40Hz-1.5kHz
Sensitivity 99.8
Magnet Weight 11 oz.
Gap Height 0.365”, 9.27mm
Voice Coil Diameter 3”, 76.2mm

Thiele & Small Parameters


Resonant Frequency (fs) 42Hz
DC Resistance (Re) 5.31
Coil Inductance (Le) 0.92mH
Mechanical Q (Qms) 6.82

KAPPALITE™ 3015LF Neodymium


Electromagnetic Q (Qes) 0.41
Total Q (Qts) 0.39
Compliance Equivalent Volume (Vas) 158.8 liters / 5.6 cu. ft.
Peak Diaphragm Displacement Volume (Vd) 846cc Recommended for professional audio and bass in a vented enclosure.
Mechanical Compliance of Suspension (Cms) 0.14mm/N
BL Product (BL) 18.6 T-M
Diaphragm Mass inc. Airload (Mms) 101 grams
Efficiency Bandwidth Product (EBP) 102
Maximum Linear Excursion (Xmax) 9.6mm
Surface Area of Cone (Sd) 881.1 cm2
Maximum Mechanical Limit (Xlim) 17.0mm

Mounting Information
Recommended Enclosure Volume
Vented 102-193 liters/3.6-6.8 cu.ft.
Overall Diameter 15.32”, 389.1mm
Baffle Hole Diameter 14.03”, 356.4mm
Front Sealing Gasket fitted as standard
Rear Sealing Gasket fitted as standard
Mounting Holes Diameter 0.28”, 7mm
Mounting Holes B.C.D. 14.56”, 369.8mm
Depth 7.25”, 184.2mm
Net Weight 8.6 lbs., 3.9 kg
Shipping Weight 10.7 lbs., 4.9 kg

Materials of Construction
Copper voice coil
Polyimide former
Neodymium magnet
Vented core
* Please inquire about alternative impedances.
Die-cast aluminum basket/heatsink
** Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
Paper Cone *** The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
Cloth cone edge Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25” supplied microphone (software

Solid composition paper dust cap calibrated) mounted 1m from wall/baffle | 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu.ft. chamber with
fiberglass on all six surfaces (three with custom-made wedges)

You might also like