Scribd
Upload
64 views

Arduino Injector Control

This code defines pins for a potentiometer, LED, and transistor. It reads the potentiometer value and uses it to calculate on and off delays for pulsing the LED, with the delays varying from 20-500ms based on the potentiometer position. The potentiometer value is mapped between 0.04 and 1 to control the pulse widths.

Uploaded by

Teguh Priyono
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
64 views

Arduino Injector Control

This code defines pins for a potentiometer, LED, and transistor. It reads the potentiometer value and uses it to calculate on and off delays for pulsing the LED, with the delays varying from 20-500ms based on the potentiometer position. The potentiometer value is mapped between 0.04 and 1 to control the pulse widths.

Uploaded by

Teguh Priyono
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

1.

#define fetPin 2
2. #define potPin A0
3. #define ledPin 13
4.  
5. #define highms 500
6. #define lowms 20
7.  
8. float pot = 0;
9. float total = 0;
10. float ondelay = 0;
11. float offdelay = 0;
12.  
13. void setup()
14. {
15.   //Serial.begin(9600);
16.   pinMode(fetPin, OUTPUT);
17.   pinMode(ledPin, OUTPUT);
18.   pinMode(potPin, INPUT);
19.   total = highms-lowms;
20. }
21.  
22. void loop()
23. {
24.   pot = analogRead(potPin);
25.   pot /= 50.0;
26.   //pot = 1 - pot;
27.   if(pot > 1) pot = 1;
28.   if(pot < 0.04) pot = 0.04;
29.  
30.   offdelay = total*pot*pot;
31.   ondelay = total*pot-offdelay;
32.  
33.   //Serial.print(pot);
34.   //Serial.print("   ");
35.   //Serial.print(ondelay);
36.   //Serial.print("   ");
37.   //Serial.println(offdelay);
38.   digitalWrite(ledPin, 1);
39.   digitalWrite(fetPin, 1);
40.   delay(ondelay);
41.   digitalWrite(ledPin, 0);
42.   digitalWrite(fetPin, 0);
43.   delay(offdelay);
44. }

You might also like