Scribd
Upload
59 views1 page

Technical Letter: Watch Setting Guide

This watch guide provides instructions for setting the time and operating the chronograph feature on a ladies watch. It includes the following sections: 1. Preliminary setting ensures the chronograph hands are reset to zero before use. 2. Time setting allows the user to synchronize the hour, minute, and 24-hour hands. 3. Chronograph operation explains how to start, stop, and read the chronograph measurements from the function hand in seconds or minutes depending on the elapsed time. 4. An all reset function returns all hands to their 12:00 position, used after battery replacement.

Uploaded by

mbtavares
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views1 page

Technical Letter: Watch Setting Guide

This watch guide provides instructions for setting the time and operating the chronograph feature on a ladies watch. It includes the following sections: 1. Preliminary setting ensures the chronograph hands are reset to zero before use. 2. Time setting allows the user to synchronize the hour, minute, and 24-hour hands. 3. Chronograph operation explains how to start, stop, and read the chronograph measurements from the function hand in seconds or minutes depending on the elapsed time. 4. An all reset function returns all hands to their 12:00 position, used after battery replacement.

Uploaded by

mbtavares
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Watch Setting Guide

5.After stopping the chrono, read the chrono measurement as follows:

Technical
For measurements of less than one minute:
• Second hand shows chrono seconds
• Function hand shows chrono 1/20 seconds
For measurements of one minute to 60 minutes:
• Second hand shows chrono seconds

Letter
• Function hand shows chrono minutes
• Push and hold “B”button.Function hand will now show chrono
1/20 seconds.
• Release button “B”.Function hand will go back to chrono minutes.
FOR CHRONO SPLIT TIME:
For measurements of more than one minute only
1.With chrono running,push “C”button to indicate split time.
BOOK NO. 517 LADIES CHRONO-6W60 2.Split display lasts for 10 seconds,after which it will return to original
chrono running time.
This watch features: SECTION D • ALL RESET FUNCTION
• 60 Minute Chronograph The all reset function is used following battery replacement or abnormal
• Time display with hour, minute and second hands watch behavior.
• Electronic setting 1.Pull the “M”button to the outer position.
Please refer to the below diagram frequently when reading the operating
instructions 2.Push and hold the “A”,“B”and “C”buttons simultaneously for more than 2
seconds.
NOTE: The “M”button is both a push button and a pull switch with an “in”
position and an “out”position.It will be used both ways in the following 3.Release all buttons and push “M”button back to the in position.
operating instructions. 4.Reset all hands.

Function hand
• chrono 1/20th second hand (up to one minute)
Hour hand • chrono minute hand (over one minute)

Minute hand
24-hour hand

• Second hand
• Chrono seconds Mode hand

SECTION A • PRELIMINARY SETTING PROCEDURE


1.To insure that the starting point for the chronograph (chrono) is correct,
push and release the “M”button until the mode hand (small dial at bot-
tom) points to “CHR”. The function hand and the second hand should
move to the 12 o’clock or “0”position.If yes, go to next section “time set-
ting”.If not, go to step 2 in this section.
2.Pull the “M”button to it’s outer position.
3.Push and release the “A” button to set the second hand to the “0”or “60”
second position.
4.Push and release the “B”button to set the function hand to the “0”or “60”
second position.
5.Push the “M”button in.
SECTION B • TIME SETTING
1.Push and release “M”button until the mode hand points to “TME”.
2.Pull the “M”button to the outer position.The second hand should move
to 12 o’clock.If not, reset the hand.SEE previous “Section A” on
“Preliminary Setting”
3.To set the minute hand,hour hand and 24 hour hands (these hands are all
synchronized),Push and hold button “B”.This will move the hands in a
clockwise direction. To move the hands counter clockwise,push and hold
button “C”.
3.When the second hand on the time source you are using (i.e. clock,tele-
phone,another watch etc) reaches the 60 second mark,push the “M”
button back to the “in”position.
SECTION C • CHRONOGRAPH (CHRONO) OPERATION
NOTE: During the first one minute of chronograph operation,the function
hand ( top small dial) will run quickly and indicate 1/20 seconds.After one
minute,and up to 60 minutes,the same hand will slow down to indicate
chrono minutes.
1.Select chronograph mode by pushing the “M”button until the mode hand
is pointing to “CHR”.
2.Make sure that the second hand and the function hand move to 12
o’clock.If not,see “SECTION A” on “Preliminary setting”.
3.Push button “A” to start the chrono.
4.Push “A” again to stop the chrono.
4/2000

You might also like