Parking Brake - Test: Testing and Adjusting

Download as pdf or txt
Download as pdf or txt
You are on page 1of 3

980H WHEEL LOADER A8J04000-UP (MACHINE) POWERED BY C15 ENGINE(XE...

Page 1 of 3

Shutdown SIS

Previous Screen  
 
Product: WHEEL LOADER
Model: 980H WHEEL LOADER A8J
Configuration: 980H WHEEL LOADER A8J04000-UP (MACHINE) POWERED
BY C15 ENGINE
 
Testing and Adjusting 
980H Wheel Loader Braking System  
Media Number -RENR8675-05 Publication Date -01/02/2012 Date Updated -02/02/2012

   
i01614020

Parking Brake - Test


SMCS - 4267-081 

This procedure should be used to determine if the parking brake is functional. This procedure is intended 
to measure the maximum brake holding effort. The brake holding effort that is required to sustain a 
machine at a specific engine rpm varies depending on the machine. The variations are the differences in 
the engine setting, in the power train efficiency, and in the brake holding ability, etc.  

Personal injury can result if the machine moves while testing the
parking brake.

If the machine begins to move during the test, reduce the engine speed
immediately and apply the service brakes. 

Test the parking brake on a dry, level surface.  

Check the area around the machine. Make sure that the machine is clear of personnel and clear of 
obstacles. 
 

https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sisweb/... 5/29/2014
980H WHEEL LOADER A8J04000-UP (MACHINE) POWERED BY C15 ENGINE(XE... Page 2 of 3

Illustration 1 g00477580
Steering Frame Lock  

(1) Steering frame lock in the STORED position.  

1. Make sure that the steering frame lock is in the STORED position. 

2. Fasten the seat belt before you test the parking brake. 

3. Start the engine. Raise the bucket slightly. 

Illustration 2 g00835274
Operator Controls  

(2) Upshift gear speed switch. (3) Transmission direction control switch. 

Note: The following step will produce a Warning Category 3. The parking brake indicator will 

https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sisweb/... 5/29/2014
980H WHEEL LOADER A8J04000-UP (MACHINE) POWERED BY C15 ENGINE(XE... Page 3 of 3

turn ON and the master action light will flash. The action alarm will sound.  

4. Engage the parking brake. Change upshift gear speed switch (2) to THIRD SPEED. Change 
transmission direction control switch (3) to the FORWARD position, while the AUTO shift 
switch is in the OFF position. 

5. Gradually increase the engine speed to high idle. The machine should not move. 

6. Reduce the engine speed to low idle. Switch transmission direction control switch (3) to the 
NEUTRAL position. 

7. Lower the bucket to the ground. Stop the engine. 

8. Inspect the parking brake components for wear or damage if the machine moves during testing.  
 

Copyright 1993 - 2014 Caterpillar Inc.   Thu May 29 10:42:22 UTC+0400 2014
All Rights Reserved.
Private Network For SIS Licensees.

https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sisweb/... 5/29/2014

You might also like